answersLogoWhite

0


Best Answer

I had the same problem. It sounds worse than the old breaks. I upgraded to a break pad that has copper in it. It is a softer pad, but works great. Also get the rotors turned. That will fix the problem.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does your Dodge Intrepid make a grinding noise after putting new brake pads on?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Do the intrepid have front and rear brake hoses?

The Dodge Intrepid has front and rear brake hoses


Why does my car a 01 dodge intrepid have a grinding sound by the tire when I brake My brake pads are good and were recently changed?

Even though the brakes were recently changed, I would have the brakes taken apart and inspected. Something may have gone wrong.


What bulb needs replacing for a Dodge Intrepid brake light?

3157LL


What size brake line does a 1995 Dodge Intrepid have?

3/16"


What are the Brake line schematics for a 1999 intrepid?

The 1999 Dodge intrepid brake lines schematics diagram shows the routing of each brake line. The diagram will show the brake line routing from the master cylinder to each wheel.


Where put brake fluid in 1997 Dodge Intrepid?

Resevoir against firewall at driver's side


What brake fluid type to use on 1994 dodge intrepid?

DOT 3 or DOT 4


94 dodge Intrepid brake lights stay on when car not running?

If the brake lights stay on when the car is not running on most vehicles, including the 1994 Dodge Intrepid, there is probably a short somewhere in the wiring to the brake lights. The first place to investigate this problem would be the wires along the firewall that control the brake lights. Also, check the brake light switch above the brake pedal.


Why did 1996 Dodge Intrepid leak brake fluid out?

Failed line, seal, hose, caliper, etc.


Why doesnt right brake light on Dodge Intrepid 2001 work?

Bulb, wire, fuse, etc.


How do you change the brake light on a 2000 Dodge Intrepid?

Inside the trunk there is a turnable thumb screws where the brake lights are. Twist screws off and the brake light pops out.


Do you have to apply the brake when putting a 2001 Dodge Durango in gear?

Yes