0
Why don't my power windows work on a 1994 Ford Probe but the power locks and mirrors do If you run direct power to tip of plug going to switch they work?
Wiki User
∙ 14y ago
;lkzdnvklsdngtklajhfgjklashtiabhnsdkjfhalskjdhvkcsajdntiuahfskljabnstkljhasdiofnaksdtjbaisuthgklajsbcvilasuhtklajsndgkljshadtilukhqaet
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How can you by pass an inertia switch on 1993 Ford Probe?
If you crimp the three wires running to the inertia switch together and remove the switch, it will close the circuit thus bypassing the swich. I have a 1993 Ford Probe SE that this has been done to and as of yet it has no direct or indirect complications from doing this. If you crimp the three wires running to the inertia switch together and remove the switch, it will close the circuit thus bypassing the swich. I have a 1993 Ford Probe SE that this has been done to and as of yet it has no direct or indirect complications from doing this.
What are five instruments that dentist use?
drills, probe, dental mirrors, mouth props, burs
What is a DNA probe?
A Gene Probe is a term used to label several techniques used to identify a Gene Loci. a gene probe is often a piece of genetic material, that mirrors the target gene, and is also 'tagged' with dye so it can be identified.
All power windows wont work all fuses are good have replaced switch and still cant get power to motor in drivers door is there a master control for windows?
If you've done all that you say, then the next logical thing would be to check the continuity of the circuit. If you've replaced the switch place a propbe at the fuse block and the other probe at the switch to see if there is any power reaching the switch. If there is power to the switch, then check from the switch to one of the window motors. I suspect that one of the wires between the switch and the window motor(s) is probably broken or shorted to ground. ALSO: Does your vehicle have a safety child lock-out switch for the windows? Make sure that it is not in the lock position.
Can you put a Mazda transmission in a 1994 Probe?
Yes. Be sure to change the neutral switch from your probe as the mazda's will plug in but is wired different.
How do you change oil pressure switch on ford probe gt?
o my
What is cpt code 87650?
Detection of Strep-A by direct probe technique.
How do you find the fuel cut iff switch on a 1997 ford probe car?
find fuel cut off switch
My 93 probe has the fuel cut out switch on and refuses to start. how do I fix it?
are you sure its fuel cut out? my probe would not start traced problem to electronics inside distributor had failed [common fault on probe]
Where is the inertia switch on a 94 Ford Probe?
in the trunk. under the carpet, in the leftside quarterpanel
Where is the Oil Pressure Switch on a 92 Ford Probe?
The oil pressure switch should be above the oil filter on the back of the engine on a 2.2L.
Where is the inertia switch on 1993 Ford Probe?
hi, i could'nt find the inertia switch on my ford probe 1994 for ages. Eventually I found it just above the wheel arch on passenger side in boot but you have to remove the plastic covering. Not easy to locate. Hope this helps.
