answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2012-01-09 02:17:24
2012-01-09 02:17:24

check radiator cap for wear. defective cap can cause radiotor hoses to collapse.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


it is located under the throttlebody just follow the upper radiator hose


Usually at the engine end of the upper radiator hose in a bolt on type housing


Drain the radiator into a container. Remove the upper radiator hose at the engine and remove the 2 bolts in the thermostat housing. Remove the thermostat and clean the surfaces. Install the new thermostat ,upper radiator hose and refill the radiator.


Probably at the engine end of the upper radiator hose On the 3.5L it's just inboard of the water pump, at the end of the lower radiator hose...


Near upper radiator hose ...at end


The thermostat on a Chevy 350 is under the housing at the engine end of the upper radiator hose.The thermostat on a Chevy 350 is under the housing at the engine end of the upper radiator hose.


Should be a housing at end of upper hose (opposite radiator)


Partially drain the radiator down . Remove the upper radiator hose at the engine end. The housing is where the thermostat is located. Remove the two bolts and clean Both surfaces. Install the new thermostat.


FIRST YOU MUST REMOVE THE TWO DOG BONE MOUNTS(I THINK ITS FOUR SCREWS EACH). THEN YOU HAVE FOUR SCREWS ON THE FAN ASSEMBLY(TWO UPPER,TWO LOWER). THEN REMOVE THE TRANNY LINES, AND UPPER AND LOWER RADIATOR HOSES.


It is between the battery and upper radiator hose where it comes out of the radiator.


It is located where the upper radiator hose connects to the engine.


Most thermostats are in-line with the upper radiator hose. Check the housing where the upper radiator hose connects to the block.


Should be in housing at the end of upper radiator hose


just follow the upper radiator hose to engine, and you will find it.


Follow the upper radiator hose to the engine. It is behind there.


Where the upper radiator hose connects to the engine you will find the thermostat.


Partially drain the radiator into a container. Remove the upper hose at the engine end. Remove the 2 bolts that hold the thermostat housing and remove the thermostat. Clean both surfaces and install the thermostat, install the housing and the 2 retaining bolts. install the upper radiator hose and top off the coolant. It is located at the engine end of the top radiator hose in the thermostat housing.


Remove fan shroud Drain radiator Remove upper and lower radiator hoses Remove upper mounting bolts Lift radiator out of lower support cradle


In the connection at the radiatorhose and waterpump Follow the upper radiator hose out of the radiator. When that hose connects to your engine, the thermostat is in there.


There's always a partial vacuum formed in the radiator when the car cools, Presumably your hose was weaker than normal.


Open the hood, locate upper radiator hose, follow the upper radiator hose from the radiator to the "gooseneck" located on the engine, the thermostat is located under the "gooseneck". The "gooseneck" has to be removed to replace thermostat.


Follow the upper radiator hose from the radiator to the engine. It will lead you to the thermostat housing. Drain coolant from radiator, remove upper radiator hose from engine, remove the two bolts holding the thermostat housing to engine, remove housing, remove thermostat.


The thermostat on a 2005 Chevy Equinox is changed by draining the radiator, removing the upper radiator hose, and unbolting the radiator housing. The old thermostat can then be removed, a new gasket installed, and the housing bolted down.


Should be in a removable housing at the engine end of the upper radiator hose


it is in the housing on the engine where the upper radiator hose attaches



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.