does it happen when you use your turn signal? if so, that's the turn signal relay. that's completely normal.
There are 4 relays in the glove box of my 97 bravada
Blower motor is going bad. They are usually behind glove box area.
the most probable cause of clicking on rear brakes are weak return springs or a broken one.
A squeaking noise coming from the glove box on a 2003 Dodge Ram might be the heater blower fan. Try oiling the fan to see if it will stop. It could also mean that a screw is missing from the dash and the squeaking noise is the dash moving a little in that area.
If you look under the glove compartment, you will see that there is a plastic gear. It might have a broken tooth or teeth. Replacong the gear usually solve the problem. It also help if you find out why it got broken. Maybe the driven element is froze.
Sounds like your valves may need to be adjusted.
HVAC blower motor going bad could make a rumbling noise in the car near the glove box
cv joint. There should be noithing else to make this noise in that area
I cannot think of any reason for a clicking noise in the driver's side interior, but a fuel pump would not be my first thought, or my second thought, or any thought for that matter. The fuel pump is located in the fuel tank, and a fuel pump, if it gives you any warning, it will usually be a humming noise from the underside area where the fuel tank is, not a clicking noise in the interior. Even the fuel pump relay isn't in the passenger's compartment, it is under the hood.
the clicking noise could be you lifters are starting to go bad or your valves might be bent a lil. eather you should just take it to the shop and have them look at it soon or you could blow your motor.
You need to replace the front axle Every 80,000 to 120,000 They wear out, normal maintance
Old answer: Could be turn signal or hazard flasher. Additional answer: I had a similar problem. The short answer is that a factory recall may fix it. See my long answer at the link below. http://markdionne.blogspot.com/2006/11/2000-vw-gti-clicking-noise-behind.html
The Trees Buffer most of the noise in one area and reduces it in the other. When you cut a tree down, it increases noise in the other area due to no tree buffering the noise.