0
your fuel pump is in your tank.
its electric that's probably what you hear
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the crank sensor on a 2005 Chevy Impala?
where is the crank sensor located on a 2005 chevy impala
Where exactly is the 2000 Chevy Impala crank shaft sensor?
install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft
Why does your equinox make a ticking soung when you crank it?
If it makes the ticking sound and the engine will not crank, then either your battery is dead or the starter solenoid is shot.
What electric problem would cause a 2008 Chevy Impala slow to crank?
It could be a weak battery or a bad ignition coil.
How do you replace wiper crank arm for 2001 Chevrolet impala?
how do you replace wiper crank arm 2001 chevrolet impala?
Your 1985 Chevy Impala won't stay crank?
you can check your fuel pressure! check the timing, maybe even your crankshaft and or camshaft sensor. maybe weak fuel pump
Your 1997 ford expedtion will not crank and you hear a ticking sound?
Check battery and starter.
How do you remove 1968 Chevy impala window crank?
Your local auto parts store will sell you an inexpensive tool for under $10 to remove the clip from behind the handle to release handle from door.
How do you replace wiper crank arm for 2005 Chevy impala?
if your wipers shut off in the upright pos it is wiper tranmission i have one 603.485.3150 tHE PASSENGER SIDE DOES NOT WORK. tHE DRIVER SIDE IS FINE
What is the horsepower on a stock 1996 Chevy Impala SS?
The Horsepower of the 1996 Impala SS is 260 rear wheel horsepower. its not "Rear Wheel Horsepower", because 260 Rear Wheel Horsepower would be pushing like 305 at the crank. but the Horsepower for the 96 SS is 260...
Why would a 2000 Chevy Impala shut down while driving and then start back up a few minutes later?
I HAVE A 2000 IMPALA LS. I HAD THIS PROBLEM ABOUT A YEAR AGO AND I HAD TO HAVE THE CRANK AND MODULE SENSORS REPLACED. THE PRICE OF THE CRANK SENSOR IS ABOUT $60 BUT I'M NOT SURE ABOUT THE MODULE SENSOR. IN ALL,INCLUDING THE LABOR,I WAS OUT OF ABOUT $180-$200. Crankshaft sensor is the culprit; I had the exact problem.
Where is the crank shaft sensor for a 1989 Chevy van 4.3 liter?
Chevy did not use a crank sensor on that year.
