Turn the ignition switch off and on off and on until the doors lock.Press the lock button on your entry switch then press the unlock button.If the doors unlock, it is programed.If not do the process over It will finally work
You have to press the unlock button 2 or 3 times to get both doors to unlock no programming needed
If you press the unlock button two times it should unlock all the doors.
unlock all of the doors, either on your key or from inside the car by pressing the unlock button manually. you have to press it twice to unlock all of the doors.
press your 5 digit code to unlock the doors and if you want to lock the doors press the last two keys together. also after you press your 5 digit code if you the second button (3-4) it will unlock all the doors.
YES! To lock the doors, press the 7 and 9 buttons at the same time.To enable or disable the auto lock feature, enter your five digit code, then press and hold 7, press and release 3 (while holding 7), then release 7 after releasing 3.
If you have a newer model, with the remote unlock built in to the ignition key, press the button that looks like a trunk opening. This will open the tailgate but leave the other doors locked. Otherwise, press the Unlock button TWICE - this will unlock ALL doors, including the tailgate.
With the doors unlocked, turn the ignition key on the 96 Bronco from of to run and back to off five times in ten seconds, ending in run position. The doors should lock then unlock, indicating the vehicle is in program mode. Press any button on the remote, and the doors should lock then unlock. The system should now be programmed and ready for use.
Press the " U " on the lock/unlock switch located on either the driver or passenger door.
# Close all the vehicle doors. # Insert the ignition key into the ignition lock cylinder. # Press and hold the DOOR unlock switch. # While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF. # Release the DOOR unlock switch. The doors will lock and unlock to confirm the program mode. # Press and hold the LOCK button and the UNLOCK button simultaneously on one keyless remote. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter. # Repeat the previous step to program up to four transmitters. # Turn the ignition switch to the RUN (one more click forward) position in order to exit the keyless entry transmitter mode. # Operate the transmitter functions in order to verify correct system operation.
Manually you can unlock the door using the inside lock (above the handle). Toggle it so the 'red' portion shows and the door is unlocked. With the remote, press the (unlock) button twice. The first press unlocks the driver side door, second press unlocks the passenger side. There's yet another option. You can set the door locks so both the driver and passenger doors unlock when you put the transmission in park (and lock when you put it in gear). You'll find that information on page 22 of your owners manual. Actually, you'll also find the other 'how to lock/unlock' info in the owners manual too. Cheers
Just press the SETTINGS button, go to doors and locks, scroll down and go to PASIVE ENTRY