check the tracks, there may be a pen or some other foregin material lodged in there...maybe a bad track... also everyone should have a manual for their vehicle, and a professional shop manual should be available at the library in the reference section--you can make copies of the necessary information...good luck :)
on front (or wherever your belts are) of engine for CIB or on heads for OHC
Check the fuse. Most likely it needs to be replaced as it's both seatbelts and not just one, if it's just one, it might be a mechanical problem to which I dont have the answer.
Hello! The crankshaft position sensor is located behind the crankshaft pulley,on the left side facing the front of the car.It is difficult to see and to remove it you need to remove the crankshaft pulley ( radiator,belts,.... )
Right side of the engine comp. at the front of the engine by the belts yellow dipstick
Sensor is located on the top part of valve cover at the front nearer the drive belts. Three wire connector to it has wire colors Blue, Black w/ Red stripe, and White w/ Red stripe.
The crank position sensor is located on the front of the engine, behind the lower crank pulleys.
It is mounted on the front of the block at the crankshaft. It is bolted on the driver's side of the engine.
6.14 (The first column in front of the point is the ones. Therefore 6 ones. The first column is the tenths and the next is hundredths) *Th* as a suffix indicated (in maths) any position or column after the decimal point (.) .
does a 2002 mazda protege have a front wheel drive
Yes, the Mazda 2 is Front Wheel Drive
The Mazda 3 is front wheel drive.
The 1965 came with lap belts for the front seat only. This was a new law for 1965 and only required front belts.