0
The manual transmission has a starter interlock which prevents the engine from
cranking unless the clutch pedal is depressed
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you reset the fuel pump on a 1991 ford ranger?
Push the reset button.
How do you reset fuel shut off switch 1994 ford ranger?
push the button down
Noises when you push gas pedal?
ticking noise when the gas pedal is pressed in a 2005 ford ranger
Where is the fuel filter on 2002 ford ranger?
i have a 2003 ranger with a 3.0 L i tried to do the same thing the clips do not come off you have to push and pull them every body told me pry them off so i did and broke both fuel lines costing me 200 dollars to replace them i hope this helps you
Can you push start a 2003 Manuel car without a key?
Not without the key, no.
How do you change a window handle on a 2000 Ford Ranger?
it requires a slide tool to push u clip out. most parts store have tool
Where is the schrader valve on a1989 Ford Ranger?
It is the tiny valve that lets air in to your tire but not out (unless you push it in with a nail or similar "pointy" thing)
You push in the clutch on a 1999 ford ranger and turn the key and nothing happens This does not happen every time?
switch under dash on clutch is bad
Have a 1993 ford ranger 4x4 manual trans and just quit cant shift to any gear?
When You Push The Clutch In Make Sure Its To The Floor
Why won't ford ranger diesel push start It has manual transmission.?
Because you have to have the clutch depressed to start it. They came factory with a clutch safety switch that will not allow the engine to start unless the clutch pedal is pressed to the floor . NOT. the clutch safety switch only allows the starter to be energized... If the glow plugs will cycle then the truck can be pulled to start. When my starter solenoid was bad I pulled it to start.
How do you remove the hydraulic clutch line from the slave cylinder on a 1992 ford ranger?
push in line pull back teflon sleeve evenly then pull back
What year did ford stop using push rods in the 3.0 liter motor?
The last model year for the 3.0 liter " Vulcan " V6 engine ( which is an OHV / pushrod style engine ) in the Ford Ranger was ( 2008 )
