When the wheel bearing was replaced did the axel get pulled out of the transmission ? it might not be all the way in ,or it could of hit the seal and tore it !
I would have to guess it is a front wheel bearing. Does it pull to one side? Are your tries good - a bad tire could make a similar noize. It's a wheel bearing. Just replace one on my 2000 Stratus.
The cost for a wheel bearing replacement will vary based on the brand of the car. For example, a Lexus dealership quotes cost averaging about $800 for a replacement.
probably a replacement item. A wheel bearing assembly. Just a bolt on piece.
A wheel bearing replacement price rangers from around $250 to $400 depending on what model and type you are searching for. I hope this answer helps you.
Remove the tire and wheel. Remove the and to the axle. Remove the wheel bearing seal, with a seal puller. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
185 ft lbs
Remove the tire and wheel from your 1982 Chevy Corvette. Remove the brake assembly. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel seal and the wheel bearing. Reverse the process to install the new wheel bearing.
Possible causes include a bad tire, a failed wheel bearing, a failed transmission bearing, etc.Possible causes include a bad tire, a failed wheel bearing, a failed transmission bearing, etc.
Front or rear?
There are two speed sensors on the front of the transmission and one abs wheel speed sensor at each wheel bearing.There are two speed sensors on the front of the transmission and one abs wheel speed sensor at each wheel bearing.
The vehicle speed signal comes from the transmission speed sensors on the front of the transmission. The abs sensors are at each wheel bearing.The vehicle speed signal comes from the transmission speed sensors on the front of the transmission. The abs sensors are at each wheel bearing.
not if you re pack the bearings!
Changing a wheel bearing safely requires a large press. On a 1995 Jetta the wheel hub assembly must be removed and the bearing pressed out, just as the replacement unit needs to be pressed in.
probably a wheel bearing
2wheel id different than the 4 wheel ,which do you need ?
check your wheel bearing
$185.00 parts and labor front left side
The speed sensor, on your Dodge Stratus, is located on the back of the transmission. The speed sensor has a wire leading to the front wheel.
The front spindle must be removed as the bearing is pressed in. Not a job for a beginner, but if you have some auto expertise, not too difficult...
How do you replace a rear wheel assembly?
Top of rear axle.Could be one at each front wheel bearing.On driver side of transmission.Top of rear axle.Could be one at each front wheel bearing.On driver side of transmission.
The front bearing for a Dodge Stratus is attached to the Hub. To replace it remove all the components on the hub assembly. There are three bolts that hold the assembly in place. Loosen the bolts and pry out the hub. Replace the unit.
The NAG1 transmission uses the wheel speed sensors (at each wheel bearing) as the output speed signal.
I am getting quoted 300-400