0
Why would a 1993 Jeep Wrangler YJ 4-cylinder have oil in the bottom of the throttle body?
Wiki User
∙ 12y ago
high miles and blow by gasses can build up...dealerships charge to clean and service throttle bodies...
also, make shure pcv is clean, etc...
also
everyone should have a manual for their vehicle, and a professional shop manual should be available at the library in the reference section--you can make copies of the necessary information...good luck :)
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you do a carb kit in a 1990 jeep wrangler?
Your 1990 would have throttle body injection, not a carburetor.
Why would a wrangler idle high after warming up?
check your Idle sensor which is attached to your throttle body. This ussually goes bad and tends to rev the idle up. I had the same problem with my 99 wrangler.
Why would your 1991 jeep wrangler cut out when you press on the clutch as you come to a stop?
Check your Throttle control sensor... mine does the same thing Check your Throttle position sensor... mine does the same thing
What would cause a 97 jeep wrangler to idle at 3500 rpm?
unrestricted airflow into the intake. Check your throttle plate and associated sensors. Also gas pedal or cable may be binding or stuck holding the throttle open.
Would a hard top from a 1998 Wrangler fit a 1994 Wrangler?
No, it will not.
What would cause a 1998 Jeep Wrangler Sport 6-cylinder to hesitate after coming to a stop?
Easiest and cheapest trick is the good old 02 sensor -OR- Make sure that the throttle body isn't coked up with carbon as they can do that.
Why would a 89 jeep wrangler lock into gear?
My jeep wrangler keeps loking in gears
Where is the location of the throttle sensor in a 2000 S10?
The TPS (throttle position sensor) would be found on the throttle body on the opposite side of the throttle cable.
What would cause your 1999 Jeep Wrangler 4.0 to start only when given gas manually?
Possible faulty throttle position switch, idle control valve or dirt / scum in the small galleries of the intake / breather to throttle body pipes, did you get an engine management light come on when this happened? possible fault code retrieval to help diagnose prob'.
Does 1992 s10 have throttle body or carburetor?
That would be throttle body injection (TBI).
How do you install Throttle position sensor in 94 La Sabre?
Your TPS is located toward the bottom of your throttle body. If lucky, you can remove it with an offset screwdriver, otherwise you will need to remove the throttle body so you can turn it over and have access to the TPS. I had to unplug my MAS, EGR, IAC, and TPS, remove the air inlet between the air filter and throttle body, remove throttle cable mount and remove two brackets, 1 under and 1 behind the throttle body before it would come off and allow access to the TPS screws. A lot of work for 2 little screws. If there is a simpler solution out there, I would really love to hear about it. I would rather work smarter than harder.
Where is the throttle pedal sensor a located at on a 1997 Chevy S10?
The TPS (throttle position sensor) would be found on the throttle body, opposite side the throttle cable is attached to.
