There is sometimes a separate flasher for the four way curcuit.
try replacing all sets of fuses for the hazard and the tail lights.
check the fuses and then check the flasher relays
Check Flasher and/or switch
If the lights come on but do not flash, replace the flasher relay. If they will not come on check the fuses.
== Hazard and turn signals switch are different. Sounds like you need a new turn sig. switch. The turn signals are routed through the hazard switch. Re-check fuses 4 and 19. If they are fine, check/test the hazard switch and related wiring; if the switch is faulty, replace it. If the switch is good, check/test relay in position 12.
Two different switches. The combination switch on the column is most likely the culprit. This may be fuses. The turn signals and hazard lights are fed by separate circuits.
Check the fuses and it may be the flasher relay as they have 2 try turning the hazard lights on and off a few time as you relay may be stuck.
Check your relay switches that should be located near the fuse box.
Try replacing the turn signal flasher
If lights light up but do not flash, then need to change the flasher, if no light at all chk all fuses first.
Check your fuses. See owner's manual for location and assignment of fuses.
my daughters 1991 miusbishi montero has no break lights , turn signals or hasard lights . All tail lights and front markers are working. All fuses are cking good and all bulbs are good..Is my blinker switch bad ? capri
the turn signal flasher may be the problem moast vehickles have one forturn &one for 4way
Check the fuses first.
you should try checking the fuses and replacing the bulbs the fuses for thos lights should only be about a 10 or a 15
Try replacing the hazard flasher. If that does not work, double-check to see that you have the proper bulbs and fuses installed for the brake lamp circuit.
Check the headlight switch.
It needs checked out but both the hazard and brake lights go through the turn signal switch.
fuses are ok. replaced ignition multifunction switch and hazard, turn signal, cruise etc. switch. checked grounds. hazard lights when ignition is off but not in the on position. thanks Joe lapointe
check the front flasher
The only thing common to all those lights (but not to the center brake light) is the hazard switch. I'd check that next. On my 96 Century the hazards override the signals and brake lights meaning that the signals and brake lights must be wired into the hazard switch somehow.
I replace my flasher fuse.Now they light up but won't blink.
Separate circuits, separate fuses, separate flasher relay. Check the hazard fuse, hazard flasher and hazard switch.
94 mercury grand marque dashboard, hazard, and tail lights do not work?
More detail: the turn signals slowed down gradually and then stopped working. All lights still flashed when hazard lights switch was activated. The bulbs and fuses are all okay, and I have replaced the hazard flasher (which I think is a combo hazard/turn signal unit). Can't see any other flasher unit under the panel, don't know what else to try. Any ideas?