I would first check to make sure the security chip is clean and well seated. I had to get mine replaced as my Jeep was doing the same thing.
Another possibility is that that the idle air valve may have carbon and gunk built up on it. This part bolts onto the throttle body, but is relatively easy to get to once the throttle body is unbolted from the engine. It can be cleaned with a can of carb/choke cleaner, which is cheap. You would need to have a set of torx sockets to remove the valve from the throttle body to clean it, but you will only be removing two screws, so I would recommend borrowing some if you don't have any.
City driving tends to be stop and go, with many traffic lights, other vehicles and pedestrians. Driving on the highway is, usually, more straight forward, with less stops unless there is an accident, or a traffic jam.
Reverse light switch is probaly connected to switch on transmission check connections
head lights Jeep Wrangler 2004. They don't work where should I start
I have a 99 Sahara and have had to replace the switchint he dash twice. Fairly easy job about 30 buck or so. Your headlights must be on and they will only woirk when you have the low beams on. they turn off when you switch to highbeams.
Check fuses or headlight switch
Street lights help pedestrians to walk safely after sunset. The car drivers find it convenient to drive smoothly,as driving in a highway without street light is a nightmare. Well, the hellogene lights emits particles that are injurious to eyesight and human skin. On the humourous note, street lights cause inconvenience to those who commit highway robbery and darkness is the precondition to their professional job !
City driving is ; driving at slower speeds, stopping at various stop lights, sitting at stop lights. City driving (as opposed to highway driving) is considered harder on the car, it wears out faster. A car usually has two different fuel efficiancy ratings (mileage) - since city driving takes more energy, the mileage for 'city driving' is lower than for 'higway driving', where the car travels for longer distances without having to constantly stop and go.
I just had the same problem .It was my starter if i hit it with a hammer it would start
You could have a blowen fuse or a faulty connection!
with wires
where is the fuse for driving lights for a 2010 ford escape
There are a couple of reasons why a 1993 Jeep Wrangler tail and brake lights may not work. The light bulbs may be blown or a fuse may need replaced.