Mufflers and Tailpipes
Antifreeze and Engine Coolant
Chevy Beretta
Chevy Blazer S-10

Why would antifreeze be pouring out of the exhaust on a 95 Chevy Beretta?

293031

Top Answer
User Avatar
Wiki User
2005-09-12 15:39:17
2005-09-12 15:39:17

Blown head gasket or a cracked head. Do not drive this car. Serious engine damage will occur.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how to replace a 1990 Chevy Beretta battery

User Avatar

It has 1 O2 sensor on the exhaust manifold behind the engine

User Avatar

i have a 1994 Chevy beretta and they are under the engine

User Avatar

Heater box drain It is just below the heater hose conections, If the heater core leaks it drains the coolant outside to keep the carpet dry.

User Avatar

Look under the car on the exhaust near where the pipes merge together. There should be one.

User Avatar

Does anyone know of any chevy beretta cam shaft problems?

User Avatar

how to change third or center brake light on Chevy beretta 95

User Avatar

There are no rear struts in the Chevy Beretta. Only shocks.

User Avatar

the beretta and lumina motors are about the same i have a lumina motor in my 95 beretta

User Avatar

Ebay. Just enter Chevy Beretta under parts and accessories

User Avatar

depends on engine, mounting, body, ecm, and about a million other things, but possibily

User Avatar

can someone give me a diagram of a fuse box location for a 1993 Chevy beretta

User Avatar

7 liters of 50/50 mix (half a liter shy of 2 gallons). Don't over-fill it. ;-)

User Avatar

if it is the same size. 3.1 for 3.1 or 2.2 for 2.2 go ahed and do it. you may need to switch intake or exhaust manifolds so all the wires and such line up.

User Avatar

Yes it will, but you have to put all the blazer engine stuff onto the beretta engine...

User Avatar

I am trying to find the 1988 chevy beretta computer module and where is it located?

User Avatar

There are two of them on a 1996 Beretta. One is mounted in the rear exhaust manifold. You should be able to see it by looking under the hood, straight down the back of the engine. The other is located just before the catalytic converter. Poke your head under the car and look for the big "bubble" in the exhaust pipe closer to the engine.

User Avatar

The temperature sending unit for a 1995 Chevy Beretta is on the front of the engine. It is between the front of the engine and the radiator inlet/outlet.

User Avatar

The regulator on a 1994 Chevy is inside the alternator.

User Avatar

Is it water or antifreeze ??? It is probley condensation. If it is cold outside were your at then this is what happens. The exhaust system is cold and when you start the engine the exhaust heat flowing through the cold exhaust pipes makes the exhaust sweat. And it looks like water is running out. Engine is running lean. Needs richen up. If it is antifreeze it will be smoking real white out of the exhaust. And that would mean a head gasket is leaking coolant into the piston cylinder. That is the most common problem with a antifreeze leak causing white smoke. I have seen intake manifolds leak coolant into the cylinder head ( runner ) but it is rare that happens. I don't think you have a problem.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.