why could bacterial colonies found in the first section of a streak plate but not on sections two and three
so that you can get isolated colonies in the last streak . . . As you streak contineously you inoculum quantity decreases . . there by when you reach the end of last streak you get separate and isolated colonies . .
LB Broth allows you to create a suspension of bacterial cells from your original colony growing on an agar plate. It provides the necessary nutrients and environment for optimal replication. In suspension, bacterial cells can be plated onto more agar plates, in order to create a streak to cultivate colonies from a single cell, or used to in purification reaction in order to extract the transformed plasmid.
The main advantage of T- streak method: 1. To get a very good isolated colonies.2. To obtain pure culture from mixed culture.
G+ and tan
what is the streak of sedimentary rocks
Re-streak the center of the 'star' colony (transformed surrounded by satellites) on a plate contains the antibiotic, typically ampicillin. The colonies in the tertiary streak will most likely be the transformants. If you want to be quite sure, pick a single colony from the tertiary streak and re-streak again on a plate containing the antibiotic.
The streak plate method makes it easier for colonies of bacteria to grow. It also generally leads to individual colonies that look like small dots, rather then simply a mat of bacterial growth.
The streak plate method makes it easier for colonies of bacteria to grow. It also generally leads to individual colonies that look like small dots, rather then simply a mat of bacterial growth.
When using streak plates, the colonies should appear along the streak lines. This is where the bacteria have been introduced and is the first place they will grow.
so that you can get isolated colonies in the last streak . . . As you streak contineously you inoculum quantity decreases . . there by when you reach the end of last streak you get separate and isolated colonies . .
The streak lines would show a lot of colonies.
to under stand the principle of bacterial isolation
It depends, if there is no growth or colony appearance on streak line and only it shows growth in b/w the streak line then it is certainly a contamination and if there are colonies on streak line and not ressemble with the streak culture then also it is a contamination but there can be a chance that colony appears due to some fault in streaking procedure and the inoculum drops between the streak line so it depends.
The best thing to do is get a nutrient agar plate and spread the bacteria using a streak-plate method of isolation to grow the different colonies individually. (And you could do a second streak-plate from each type of colony you see just to make sure that your colonies each contain only one type of bacteria.) From there you can identify and grow each pure culture. (Also, you could use selective medias.)
LB Broth allows you to create a suspension of bacterial cells from your original colony growing on an agar plate. It provides the necessary nutrients and environment for optimal replication. In suspension, bacterial cells can be plated onto more agar plates, in order to create a streak to cultivate colonies from a single cell, or used to in purification reaction in order to extract the transformed plasmid.
Between each set of streaks you sterilize the inoculating loop in the Bunsen flame. At the beginning of the next streak you overlap with the end of the one before. The effect of the technique is to "dilute" the bacteria by gradually spreading then over greater distances. Eventually, a point is reached where single bacteria are spaced sufficiently far apart for single colonies to grow without infringing their neighbors.
Bcs to get less dense colony