Your caliper needs replaced. The piston inside is corroded, and is not releasing. The new caliper costs about 24 bucks at the part store. Hope I could help.
because your brake pads or ABS in broken. take it to macco they fix it up right
The small black lever is the accelerator and the large lever is the front brake.
it is possible that your brake hoses are bad and soft not letting the brake fluid back out of your calipers
If only the right rear brake/signal light is effected it is not the fuse. Inspect the right rear brake/signal bulb, socket and wiring.
Easiest would be to disconnect the wire at the emergency brake handle.
Looking over the right front fender on a V6 it is at the front of the engine on your right side.
Right in front of the pump, looks like integral part of the pump, made of brass. Be careful not to brake short high preassure line connector to the fuel filter. Fairly expensive and easy to brake.
Jack up and support the right front of the vehicle. Remove the wheel/tire. Remove the brake caliper and hang the caliper with a piece of wire out of the way. Remove hub/rotor assembly. Remove backing plate and spindle. Slide out axle assembly. Replace u-joint as you would on a driveshaft. Assemble in reverse order.
Look right around the carb, it should screw in right by the carb directly in front of you if you are standing right in front of truck
The filler cap on the 1200's is on the right side, ( foot brake side ) right near the dip stick.
Hi' Can't answer your question but I am looking for 1985 Gold Wing Aspencade 1200 cc mirrors and I have no luck so far. I can use the right side (front brake ) more so than both. If you have anything that can help me out, please answer. I would do the same for you. Al (aj496@hotmail.com)
It's right in front of you - behind the instrument panel to be precise. At the back of the cowling you will find two depressions; grab them and pull the cowling up and towards you. You'll see the reservoir behind the instrument cluster.