"It's possible that you blew the low beam filaments. I blew my high beam filaments while charging the battery." --MM
There is one fuse for the left highbeam and one for the right. The left fuse was loose.
It's most likely that your headlights are just dead. There are separate filaments for your headlight and your highbeam, so odds are both headlight filaments are burned out, but your highbeam filaments (which probably get used less) are still fine. It's not unusual for both headlights to burn out at the same time. Throw in another pair of headlights, it's probably the cheapest thing to rule out and the most likely solution.
Check the headlight bulbs.
The headlights are on two different fuses. The high beams are on one fuse and the low beams are on another fuse. The fuse for the low beams may need to be changed.
The headlights are on two different fuses. The high beams are on one fuse and the low beams are on another fuse. The fuse for the low beams may need to be changed.
Well, assuming that you are talking about headlights, the low beams are the dimmest settings for the drive headlights, while high beams are the brightest setting.
Check all fuses and check for burn out headlights, high and low beams
Your headlights turn off when you turn the high beams on because you have a defective switch. You need to have a mechanic replace the high beams switch. It is a simple replacement.
On a '93 Ranger there is an independent fuse in the underhood power distribution center just for the highbeams. Check continuity if it is good, you may have 2 other possibilities. Either the highbeam capsule bulbs are burned out or you have a problem with the highbeam multifunction switch. !!
one or more headlights don't work but others do.none of the headlights will work.high beams work but low beams don't and vice versa.lights flicker and sometimes go dim.
ask this to the dumb mind of the dodge creator.
Answer: on the turning signal switch turn the handle forward for headlights. high beams pull in to flash. push out for high beams to stay on.