Yes it will set right in there if you know what your doing.
A small block 350 cc engine will not fit a 2005 Impala, but a 327 one will.
The later 327's were exactly the same as the early 350's, so yes, a 350 crankshaft will fit a 327 block if it's a 1967 and up block.
will it bolt up to a700r4 transmission
305 327 350 400 283 with a little modifications
It fit a 1968 to 1992 chevy small block.... Do NOT put it on a LT1
Yes. 403 is a small block with identical exhaust ports as a 350 and 330.
Yes, a 283, 305, 307, 327 etc will fit. You should be able to use small block motor mounts from 1966
a 350 is a small block those heads will fit on and Chevy SMALL block not a big block
Yes.
it depends if the 86 caprice has a GM small block 305, 327, 350, or 383, and if the c1500 has GM small block v8 it will fit.. all GM/Chevy 305, 327, 350, or 383 engines have the same bolt pattern for all the transmissions and are interchangeable as long as the transmission came off of a 305, 327, 350, or 383 block it will fit those engine sizes, unless the truck is 4X4 than it wont or you would have to eliminate the 4x4, also it could be a possibility the drive shaft could be to long or to short but most trucks have an adjusting drive shaft so you wont have to worry
it should be any 4 bolt main small block, like a 305 350 383 400 327 you could even upgrade to a big block, but you may run into some trouble with engine mounts.
Actually the complete distributor will fit from the small block to the big block.