0
With a new pool surface installed- Diamond Brite or any aggregate surface- is it possible or doable to acid wash the pool with water in the pool?
Islandswede
If you did you would end up with very acidic water. a good way to clean pool surfaces with the water still in in most case, it is to simply use a high pressure water sprayer with nothing but water. You will end up with cloudy water that you can then hit with a clarifier allow it to settle for a couple of days and vac the layer at the bottom to waste.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What you mean by acid water?
With a new pool surface installed- Diamond Brite or any aggregate surface- is it possible or doable to acid wash the pool with water in the pool??
What would cause a Diamond Brite pool surface that has been recently installed to not adhere to the original plaster surface and start coming up in sheets?
You say that it did not adhere to the original plaster surface. That being said the proper prep work required when plastering over an existing surface was not done properly. Diamond Brite as well as other exposed aggregate finishes would not come off in sheets unless the applied surface was not properly prepped. Without knowing the condition of the existing surface I won't be able to tell you weather the finish should have been sandblasted or if it were structually sound enough that a acid wash, pressure wash and bonding coat would have done the trick.
Why does the back surface of your diamond have a silvery substance?
If you have a silvery substance on the back surface of your diamond, it is not a diamond.
Why the metatreder4 is not installed on Microsoft surface PC-?
The Metatreder4 is not installed on Microsoft surface PC because it is not supported.
What is a sentence using the word aggregate?
A road surface is made up of tarmac, over a layer of hardcore which has been spread on a layer of aggregate.
Is plaster or combination aggregate surface better for a gunite pool in the North East?
Combination aggregate finishes are stronger and just as smooth if applied correctly. 1 part white cement and 2 parts marble dust is generaly a good marcite finish.On exposed aggregate finishes such as "diamond brite" exposing it by acid washing takes 2 years off of the lifespan. Wait until it needs washing and then do it.
How would the determination of bulk specific gravity of fine aggregate (Saturated Surface Dry basis) affected by the 500gm sample being drier than the surface-dry condition Explain that the aggregate?
[object Object]
What is flat surface of a diamond called?
The flat surface of a diamond is called the table if it is on the 'top' of a cut diamond. Otherwise, the flat surface is called a facet, some with specific names. Read more, below.
Will surface of a diamond be scratched?
Yes, perhaps, if scratched by another diamond.
What happens to aggregate concrete if the muriatic acid was not completely rinsed off?
pitting and flaking of the surface
Does sizes of aggregates affect the compressive strength of concrete?
Larger the size of aggregate will decrease strength of the concrete because surface area of this aggregate is low.Lesser the size of the aggregate will lead to increase the strength of the concrete.Well graded aggregate have all size of particles hence particle interferance is neglected,thus strength of concrete is more.
Sand or gravel that naturally forms near earth surface is known as?
Sand or gravel that naturally forms near earth surface is known as aggregate.
