switch on the transmission which sends a signal to the reverse lights when shift is in reverse......... is shot. You need a mechanic.
Have you ever changed the fluid and filter in the transmission? If not, that's the first thing you should try.
It's probably your transmission.
There can be several things that will cause your transmission not go into reverse. The most common cause is the gear in the transmission is worn.
If your 1995 Chevy 2500 truck won't go in reverse, you got some transmission problems.
An s-10 transmission with no reverse most likely has an internal problem. The shifter fork or a gear issue can cause no transmission reverse.
I am curious to know which oil you changed. Usually when one says oil change, they are referring to the engine oil. When referring to a transmission, one usually says they are doing a transmission fluid change. You mention the oil came out red. Red is the color of transmission fluid. I'm wondering if you drained the transmission fluid thinking you were draining the engine oil. If so, the transmission is empty and that would be the reason for no reverse or drive gears.
transmission leak in reverse only
If it still has a reverse, just in the wrong place, then the linkage or cable from the shift lever to the transmission has streched or fallen out of alignment.
well it could be the transmission bracket or ur motor mounts but im not real sure
95% of GM autos with no reverse will need to repair the transmission 95% of GM autos with no reverse will need to repair the transmission
It's a matter of replacing the reverse position swith in the transmission. This switch tells the computer wheter it's in neutral, or reverse and when in reverse it triggers the reverse lights.
If it is an automatic transmission then your reverse clutch pack is probably burnt out in which case your transmission needs to be rebuilt If it it a manual transmission and it wont go into the reverse gear it is probably a shift synchronizer.
Depends on the transmission. Many transmission bands are not adjustable.
Put the van on the lift and drain the transmission fluid, next drop the transmission on a tranny jack and proceed to do a transmission overhaul. Reverse the proceedure to install.
No it is not reverse thread. The passenger side rear spindle is the reverse thread on 88-93 festivas.
If your van won't go into reverse, the transmission might be stuck. It could also be low on transmission fluid.
possibly a bad linkage between your shifter and your transmission, if that's not the problem its the reverse gear in your transmission
If a transmission for a car becomes stuck between 1st and 2nd gear the fluid should be changed. Old fluid in a transmission can cause hard shifting and stuck gears.
If you mean the transmission itself shifts forward, it is because the transmission is suspended, so when the transmission is put in reverse gear the momentum will push the transmission forward. Now, if the car pulls forward when put in reverse, this means there is a transmission problem. This may just indicate the shift linkages need adjustment, or that the transmission has a major problem and needs repairing. Take it to a shop and have it checked.
transmission is gone.
It is probly your transmission.
Tranny is shot.The reverse gear in your transmission had burned out