0
You have a 1992 Ford F150 4x4 you replaced the steering colume in it checked the fuses in the cab but turn signal and brake light still don't work at a lost?
Wiki User
∙ 18y ago
You need to replace the turn signal flasher which is near the column under the dash, then take a 12v circuit tester and check your stoplight switch; replace if necessary. Lastly, clean bulb sockets out and test bulbs. One of these areas should lead you to the fix.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Where is the fuse for turn signals on a 1989 Mercury Cougar located?
in the steering colume there is a little box connected to turn signal you replace that little box but you have to take lower colume off.
2001 cavilar left rear turn signal wont work i replaced bulb and checked fuse still wont work can you help?
Check for a bad socket Turn signal flasher? Switch at steering column?
1997 lumina you have no brake lights but your back dash light works?
It's the turn signal switch at the steering wheel, that is the problem. Very exspensive to get replaced,and to hard for an amuture to do. If you have checked all fuses and bulbs sounds like ur turn signal switch in ur steering wheel. I had the same problem and was switch.
Where is the hi-lo beam switch in a 1983 Pontiac Trans Am?
If the dimmer control is built into the turn signal lever rather than on the floor, then the switch will be inside the left side of the steering colume.
Brake lights out on 95 Olds Cutlass Supreme. Turn signals work and fuse is good. Brake switch checks out good also. Any thoughts on where I am loosing power?
its in the steering colume replace the turn signal switch
What would cause your blinker to stop working you checked the fuses and flasher?
Next check the turn signal switch inside the steering column. check to see if the bulb is dead
Where is the turn signal fasher on a 98 buick park avenue?
No flasher, it is a relay above steering column right side, its way up there. If you have one signal, working it is the switch in the steering column! Just replaced mine; it cost $500 for the switch! But it's not hard to change, there's no need to pull the steering wheel. Just remove the plastic cover behind.
1997 Lumina. Hazard lights cruise control blinkers tail lights work. Brake lights do not. Replaced activating switch and turn signal switch bulbs fuse checked for corrosion and broken wires. Pls help?
To replace turn signal control module requires removing steering wheel. Took mine to a dealer - $245 out the door. Brake lights work great now.
No turn signal no emergency flasher no brake lights fuses all ok checked turn signal swithch ALL OK help 1987 F-150?
Had short in trailer light, blew fuse, checked traile, thought fixex, did not, blew turn signal fuse along with emergency flasher fuse, checked again, found problem, but no lights, replaced fuses, nothing works, have checked everything I know, even pulled stering wheel checked swith, nothing wrong, has me at wits end, plesse advise
Why would your low beams not work if the fuses have been replaced and the headlights have been replaced and the relay box has been checked?
Often it can actually be a faulty turn signal!! As silly as this sounds it is quite common. First thing to do is clean the contacts on the turn signal, if you still get high beams and no low beams you probably need to replace the turn signal switch.
Why does a 1994 Buick LeSabre's turn signal sporatically flash when signaling to turn but work fine for hazard lights?
The front or rear turn signal flasher bulb may be burned out and needs to be replaced. The turn signal flasher my be defective and should be replaced. The hazzard lights have a flasher unit of their own. These are found up in under the dash in the steering column area.
You have a 1983 Chrysler e-class and both your turn signals and brake lights don't work you have checked your fuses and everything Why aren't They still working?
check the ground on your tailights R.W: Have you checked the turn signal switch? That may have to be replaced.
