0
You replaced the engine in 96 Mitsubishi Galant now mechanic says the transmission is shot because it blew a bearing Are they trying to rip you off?
Wiki User
∙ 18y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the pilot bearing located on a 2003 Mitsubishi Lancer?
Research indicates that there is no pilot bearing in the 2003 Mitsubishi Lancer. On some front wheel drives the clutch disk is splined to the main shaft which has two bearings in the transmission case. No pilot bearing is necessary.
Why would 01 Stratus have transmission leak after wheel bearing replacement?
When the wheel bearing was replaced did the axel get pulled out of the transmission ? it might not be all the way in ,or it could of hit the seal and tore it !
How much does it cost to replace a wheel bearing Mazda Protege?
I just replaced a wheel bearing in my, 03 protege 5 it was $60 for the part and $60 for the mechanic to press it in.
A humming noise started in the front left wheel area of your 98 grand prix the garage said it was a bad wheel bearing and replasced it Noise continued. Rotated tires. No difference.?
Mine does that. Also replaced the bearings and nothing happened. Found out my transmission is starting to go, and the mechanic says that's the cause of the noise. Returned to my mechanic. Had him take another look. Turns out the RIGHT wheel bearing was just as bad. Replaced it and problem solved.
IF 1997 Geo Tracker replaced clutch bell crank and now won't go into 5th gear mechanic says transmission needs tearing down could it be a throw out bearing?
If it was the throwout bearing, it would affect all of the gears, not just one. I would suspect a bad gear or syncronizer.
Why would the clutch pedal of a 1987 Nissan 300ZX non turbo go to the floor and stay there when there was no slippage in the clutch during drive?
Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced. Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced.
What could cause a vibration and fluctuation of speed when reducing the transmission gearing in a 1999 Mitsubishi Lancer?
a bad hanger bearing on your right front axle
What would cause a driveshaft to bind in a th350 after changing u-joint?
If all the u joints were replaced it could be a broken or frozen wheel bearing. A broken gear in the transmission, a broken bearing in the engine.
1994 integra GSR transmission makes noice when clutch is not depressed just replaced clutch a few weeks ago?
Maybe "throw-out" bearing Should have been replaced w/clutch
01 Intrepid right side trans output bearing can it be replaced in vehicle?
no u have to pull it out and go inside to fix it i am a mechanic for coles auto! i hope this help u
95 jimmy rear end bearing seal will not stay in.new parts as well?
if the bearing will not stay in, the housing is worn.this can be repaired by using a new bearing with a speedy sleeve. u will need to go to a bearing supplier to get this. a good mechanic will know what it is, but an average mechanic will have no clue. also heavy equipment mechanic will know what it is
What is needed to change a 1996 Dodge Avenger automatic transmission to a manual transmission?
flywheel ,clutch plate, pressure plate,release bearing,gear box,lever,mounting,clutch pedal.clutch pump 2,....good mechanic
