make sure timing is set correctly, make sure you are getting fuel from the fuel pump to the injectors and also make sure the coils on each plug are working properly (just some suggestions)
how to change a ignition switch on a nissan altima 2003
The engine on a Nissan Quest van may quit when stopped if the ignition time is incorrect, the idle speed is set too low, or the air filter is clogged. Performing a full tune-up will help to resolve these common problems.
How change my ignition switch nissan 2001 sentra.
'Where is ignition coil 2 in a 1998 Nissan maxima'?
Well I had an ignition coil replaced in a 1990 Oldsmobile and the coil cost approximately $50. Labor would probably cost approximatley $35.
Put the transmission in neutral or push the clutch in and then stop the car. When stopped, turn the ignition off.
I've.changed.the ignition on Nissan micra 2000 it still won't stsrt
how do i remove the ignition switch in a 1995 Nissan quest
Take the steering column housing off (usually held by 4 screws from the bottom) and remove the starter cap from the back of the ignition cylinder. In a Nissan, the ignition cylinder usually has a T shaped pin which turns the starter. if you can start your vehicle by turning the starter cap with a screw driver, you probably don't have an issue with the starter.
First you must start by removing the entire ignition, itself, on the Nissan 200SX. It should be fairly easy, you will just need the correct tools. Once you have bought the new ignition switch, attach it to the ignition and then re-install the ignition into the Nissan 200SX.
Could be a burnt out fusible link. Could also be a loose connection or broken wire in your starting system.
maybe ignition modual