answersLogoWhite

0


Best Answer

my 97 Ford Probe GT does not start sorry for the mistakes

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Your probe does not start when it is raining new distributor new cap have no spark even if the car is in the garage does nots start after it stops raining dries than you can start the car?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Ford Probe distributor?

is there a diagram or a picture of the distributor cap and rottor in a 95 ford probe gt 2.5lt


1990 Ford Probe distributor?

What is your question?


Where is the ignition coil in a 1995 ford probe gt?

Built into the distributor.


Why do the Distributor unit fails on 1995 Ford Probe GT?

There is a small ignition module (relay) that is built into the distributor that is notorious for burning up.....


My 93 probe has the fuel cut out switch on and refuses to start. how do I fix it?

are you sure its fuel cut out? my probe would not start traced problem to electronics inside distributor had failed [common fault on probe]


Where is the coil on a 1993 Ford Probe gt?

On the '93-'97 GT's the ignition coil is part of the distributor. If your coil goes bad you need to change the distributor.


Where is the distributor on 1998 Ford Probe?

there is no such thing as a 1998 Ford Probe. If there was, it would probably still be located next to the stock airbox. follow the spark plug wires.


Why would a 1991 Ford Probe turn off numerous times while driving but restart with no problem?

Ford Probe's are known for water getting in the distributor cap. If it happens on a day that when its wet outside check your distributor cap to see if theres any water in it.


Where is the thermostat located at in a 1993 v6 Ford Probe?

follow the coolant hose that goes under the distributor.


What could cause a 1993 ford probe to have no spark but your gas pump works?

distributor is likely bad


How do you set the ignition timing on a ford probe gt 95 with an mx engine?

To set the ignition timing on a Ford Probe GT 95 with an MX engine, remove the two 12 mm head bolts holding the distributor in place. Then rotate the distributor to set the ignition timing.


What is the firing order of a 1996 Ford Probe SE 2.0L?

1-3-4-2 Distributor rotation:Clockwise