check your relay for the cooling fan and fuelpump
Pump, fuse, or fuel pump relay.
Need to replace fuel pump relay.
No, there is no direct connection.
yes, there should be power if key is on
in the event of a collision the fuel pump is turned off
pump relay probably stuck
Fuel pump will not run and engine will not start.
When the ignition is first turned on you should hear the pump start up. If you do then the pump is getting power. There is a port on the fuel rail where you can put a gauge to see if the pump is putting out pressure.
near the distrubutor check fuel pump relay and fuses
For 2 or 3 seconds you will hear the fuel pump run , before starting the engine , when the ignition key is turned to the on / run position
To check the fuel pump on a 1988 Toyota pickup, first ensure the ignition is off and locate the fuel pump relay in the fuse box. You can test the pump by bypassing the relay with a jumper wire to see if the pump activates. Additionally, listen for the pump's humming sound when the ignition is turned to the "ON" position (without starting the engine). If there are no sounds or fuel pressure at the fuel rail, the pump may need to be replaced.
If the fuel pump motor is not activating when the ignition is turned on and there's no fuel flowing through the injector on a 1KZ engine with a Denso fuel pump, first check the fuel pump relay and fuses for any faults. Ensure that the ignition switch is functioning properly, as it controls power to the fuel pump. Additionally, inspect the wiring and connections to the fuel pump for any damage or corrosion. If these components are all working correctly, the issue may lie within the fuel pump itself, which could require testing or replacement.