0
no it does not,its Power Steering with a gear box
What else can I help you with?
What could cause the steering wheel to shimmy on a 98 4x4 tacoma other than tires or wheels?
Tires can be either out of balance or have a slipped belt and cause vibration in the steering wheel. Wheels can be bent and cause it. CV joints can be almost to the point of failure and cause it. Excessively loose steering components (ball joints, Rack, idler arm (if present), struts... Either the front or rear drive shafts could be out of balance most likely the front
How many hours does it take to repair power steering pump on 98 Lincoln continental?
About 2 hours.
98 blazer sways all over the road I have changed ball joints shocks new tires alignment bearings what's next?
check your idler arm for play, these blazers are known for that, check your pit man arm coming down from your steering box, front sway bar bolt & bushings and rear bushings
Exactly where is the fuse panel on a 98 park ave ultra?
Should be left lower side of dash by steering column
Have 98 s10 blazer no power when accel and makes like a loud sucking noise like vac line disconnet was told it was mass air frow sensor you don't think that's it?
Could be a plugged catalytic converter.
Rack and pinion failure on 1998 rodeo?
not sure when this was posted but a 98 does not have a rack it has a recirculating ball steering box
You have a buick lesabre custom 98 the steering is going and its not the steering fluid what could it be?
If you have plenty of fluid it could be the power steering pump itself going bad or it could be the rack and pinion assembly.
How do you replace a power steering gear box on a 1998 Chevrolet Malibu?
the 98 do not have a power steering Gear box. if your refering to the rack and pinion. do yourself a favor and go buy a haynes manual, if your talking about the power steering Pump.. again haynes.
Can you just replace the seal for rack pinion for a 98 ford contour?
Yes, you can replace the seal for the rack and pinion on a 1998 Ford Contour. However, it typically involves removing the rack and pinion assembly from the vehicle, which can be labor-intensive. Make sure to properly drain the power steering fluid and follow the manufacturer's specifications for reassembly to avoid leaks. If you're not experienced with this type of repair, consider consulting a professional mechanic.
Is it easy to install a Rack and Pinion on a 98 Saturn SL?
No its not. It is diffcult even with proper tools.
How much do it cost to replace steering rack on a ford contour 98?
1200 dollars
Does the return line fitting on a 98 civic steering rack need an o ring?
yes
What could cause a Left front popping noise in 98 Chevy blazer?
A front popping on the left of a 98 Blazer could be the brakes, steering, or wheel bearing. Check all three to find the cause.
How do you take out a Power steering pulley on a 98 Chevy blazer?
You will have to get a tool called a Power steering puller to remove the pulley. Then another tool that puts it back on.
Can you bypass a '94 Oldsmobile 98 power steering cooler that has rusted out and leaks?
You can, but you risk overheating your power steering pump and rack. Not good for the seals and they will leak for sure after a while.
Can you use any manual trans from 88 to 98 blazer for your 98 blazer?
No
What is wrong when power steering is hard to turn to right only on a 98 Chevy Venture?
Steering rack problems. Possibly time to replace. Seek professional help! Y-THINK-Y
