If it is because of the drive, it may need a flywheel also. If it keeps burning out the wiring, I would change brand of starters.
I just found the relay on my 1999 sc2.I have a standard tranny and I followed the wires from the clutch safety switch. My relay was up under the dash on the drivers side taped with electrical tape to the harness. Hard to see get agood flashlight. Probably at the top of starter- follow the + battery cable should connect to starter solenoid (relay)
You replace the valve seals on a 1996 Saturn SL1 by removing all of the hardware to get to the valves, unseating them, cleaning them, and sliding the new valve gaskets on. In order to do this you should consider getting a good Chiltons or other repair manual for your make, model, year, and engine.
The cam chain tension on a 1996 Saturn SL1 cannot be reset from outside of the motor. It will have to be accessed inside the motor. It is also a good idea to check and make sure it is not simply a broken timing guide.
crank sensor is bad
How can I replace the headlamp on a 2000 Saturn SL1
The starter on a 2001 Saturn SL1 is located on the driver's side of the engine. It is just to the left and in front of the alternator/generator.
2350lbs estimate
Remove the positive battery cable from your 2000 Saturn battery. Remove the cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.
The 95 Saturn SL1 does it too.
The relay is attached to the starter and is an integral part.
either the kick panel or on the starter itself. sometimes ther are 2 of them
lease gas cap on 2000 sl1
Check the wiring on the starter. Also check all grounds
The starter for a 1999 Saturn is on top of the transmission under the air filter box. Remove the filter box for easy access.
In the fuse box under the hood.
Yes, the SL1 is a multi-port fuel injected engine with a single overhead cam.