answersLogoWhite

0

I would focus on the battery cables especially the ground; if they are at all questionable, replace them . Make sure the ground is biting into clean metal and also add a extra ground strap from engine to frame or find and clean the existing one.Remember, the engine is setting on rubber motor mounts and connected with rubber cooling hoses and depends on the cables to transfer the electrical circuit. I hope this helps you. Mark

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

How do I replace starter to 1990 old's custom cruiser?

To replace the starter on a 1990 Oldsmobile Custom Cruiser, first disconnect the negative battery cable to ensure safety. Then, locate the starter, which is typically mounted on the transmission bell housing. Remove the wiring harness and bolts securing the starter, then carefully pull it out. Install the new starter by reversing the process, ensuring all connections are secure before reconnecting the battery.


How do you replace starter on a 1996 softail custom?

To replace the starter on a 1996 Softail Custom, begin by disconnecting the battery to prevent any electrical shorts. Remove the starter's mounting bolts and disconnect the electrical connections, including the positive lead and any other wires attached. Carefully pull the old starter out and install the new one by reversing the removal process, ensuring all connections are secure before reconnecting the battery. Finally, test the starter to ensure it functions correctly.


What could keep a 1992 buick reagal custom from charging the battery after new battery and new alternator put in?

Check a for a blown/burned out fuseable link between starter and alternator


Where do you find starter relay for 99 Buick lesabre custom?

Where do you find starter relay for 99 buick lesabre custom


How do you replace the starter on a 1988 heratge softail coustom?

To replace the starter on a 1988 Heritage Softail Custom, first disconnect the battery to ensure safety. Remove the primary cover and drain the primary fluid, then take off the primary chain and clutch assembly if necessary to access the starter. Unbolt and disconnect the old starter from the mounting plate and electrical connections, then install the new starter by reversing the steps. Reassemble the primary components, refill the primary fluid, and reconnect the battery.


Where is the starter relay located on a 1994 Buick Regal Custom?

On the top of the starter where wires connect


1994 custom buick lesabre starter bolts unreachable how to raise engine to remove starter?

where are the two bolts located on the starter?


Can you replace a starter engine on a softail custom 2007 with a softail 2006 starter engine?

probably. If they are both OEM, they are interchangeable


I have a 02 buick LeSabre custom when the key is turned to the run position all power and fuel to the engine is cut Had the starter tested works fine could it be the built in securety system?

Check your battery cables. Some computerized vehicles have to be reset. Disconnect the battery for about 5 minutes and then reconnect.


How do you turn a PSP on after custom firmware was installed without a battery?

Get another battery. You should of had backup files on your PSP battery.


Where is the battery for a 2001 Buick Custom?

the battery, surprise surprise is under the rear passenger seat.


Does a NBA bench warmer get the same custom championship ring as a starter?

yup