there should be two small squered buttons under the clock that have (H) for hour and (M) for minute
Push the set button and with the set light on, press either the scan or seek buttons to change the hours and minutes. GoodluckJoe
Borrowed from silverado answer: Push the set button and with the set light on, press either the scan or seek buttons to change...
You hold down the up and down buttons to the right of audio button
Check the fuses Should have 2 fuses for radio/clock one for radio and a separate one for the memory circuits
If its like my '90, power off the radio so that the time displays. Then, hit Set. Then the Seek/Scan buttons will change the hours and minutes. When you are finished, hit Set again to get out of Clock Setting mode.
have you tried turning off the radio and then press the set button then press the scan (up, dn) for hours then seek (up,dn) for minutes then press set again
To set the clock on a 1988 Chrysler Lebaron you start by pressing the "set" button while the radio is on and push the volume knob in. Once you see the hour number flashing on the screen, adjust by using "seek" and press the volume knob in once you set the hour and then it will go to minutes. Adjust the minutes using the same "seek" button and press the volume knob in and the time will be set.
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
With the radio off, press the set button. Scan button sets the hours, Seek button sets the minutes.
assuming this is the digital clock, you hit the clock button on the dash, followed by the reset button followed by the clock button. at this point, you should be able to hit the clock button to advance numbers, and the reset button to change the numbers you are setting. if its the analog clock, pull on the knob and turn it
not enough