If your Silverado is like most other cars today, it will use vacuum hoses to change the distribution between each setting. The vacuum in the hoses is created usually by the engine, and transferred to the switch you use in the cabin. Now if there is a slight split or crack in one of the hoses or one is loose this will lose the vacuum, which is why it will not change setting because there is no negative pressure to force the setting to change.
in the book a heater was a gun
It means a gun
A heater is a word for a gun, and Dally carries an unloaded gun for protection
In the book The Outsiders, the slang term for a gun is heater.
To answer this question the voltage of the immersion heater is needed. I = W/E.
the flap on the vent and defroster is stuck somewhere in between so it is not letting proper airflow to where you designate it possibly something sticky has fell down through the defrost vent and is constricting max. airflow
That means either you have air in your heater core or your heater core is being bypassed
The heater blower for a 2002 Chevy Silverado is mounted under the dash. It is on the passenger side, in the heater housing.
The HVAC doors that control the airflow are activated by small vacuum motors. The system is designed to fail safe; this means that the system will fail in full defrost mode. So, knowing this and the fact that you have heater but no A/C or defrost you should assume the system has a failed control head (the part that you select functions with with button or lever). Or the doors are stuck due to an warped duct system (usually high heat related).
a heater hose runs from intake to heater core to radiator. the heater core is were the heat comes from inside the car as well as defrost
The heater inlet hose is on the firewall. On the 2002 Silverado it is close to the bottom of the firewall on the passenger side.
Yes they have a heater/defroster.
ihave a 1986 chevette that when i turn defrost on it blows out heat and when i put heater on it blows out only cold air? ihave a 1986 chevette that when i turn defrost on it blows out heat and when i put heater on it blows out only cold air?
it should if you have the heater control in the defrost position this is to remove the moisture from the air
The fastest way to defrost a windshield is to turn the defrost vent on without heat or simply open the windows. Another option is to warm the inside of the car by turning the heater on.
Blocked heater core, faulty heater valve, disconnected connection to the heater valve.
Yes, the ac will run in the defrost position to dry the windshield.