Usually if the pickup goes it won't start. Year, Make, Model, Engine size would help here. Module & coil are popular also. When does it stall? Hot? cold? Idle?
Typical: Remove distributor. Use punch to tap roll pin from gear at base of distributor. Use an arbor press (not a hammer) to press distributor mainshaft out of gear. Shaft will then easily come free of the distributor. If a hammer is used, now replace the complete distributor. Unbolt the pickup and replace. Reinstall shaft and gear being sure that gear hole aligns with shaft hole. Install a new roll pin. Install in vehicle. Set ignition timing.
if its for a pickup then its dirt cheap but finding a seller is harder. and putting the pickup together is even harder.
The camshaft position sensor is located just above the oil filter on the right side (sitting in the vehicle) of the engine.
Yes.
You can only do that if there is a pickup installed in the ukulele. The pickup will have a standard amplifier jack in it. If there is no jack, there is no pickup!
It depends on which engine you have. The 2.2 has no distributor.
That should be a 2.2 engine and no, it does not have a distributor cap. It has a DIS (Distributorless Ignition System).
Need to know what engine it has.
18436572
It is on the back of the engine, just behind the distributor.
top rear of the motor, next to the distributor
It is in the back of the engine near the distributor
If you have the 2.2 L engine in that 99 S10, there is no distributor in that vehicle. It has a DIS (Distributorless Ignition System).
Back of engine, on top, drivers side, close to the distributor.
It is behind the distributor, and screewed into the top of the engine block
you might try www.haynes.com
It is screewed into the top of the engine block right behind the distributor. It is hard to get to.