The unknown element is neither a battery nor a resistor.
No, a battery is not a resistor. A battery provides electrical energy, while a resistor is a component that restricts the flow of current in a circuit.
To determine the resistance of the unknown arm of a post office box using the Kelvin method, you need to create a four-terminal connection to eliminate errors from lead resistance. Connect one pair of terminals to the known resistor and the other pair to the unknown resistor. Measure the total resistance, then disconnect the known resistor and measure the resistance again to isolate the unknown resistor's resistance.
A capacitor can be charged without using a resistor by connecting it directly to a power source, such as a battery, which provides a constant voltage. This allows the capacitor to store electrical energy without the need for a resistor to limit the flow of current.
1). 6V battery, 1-ohm resistor, 2-ohm resistor, all in series:Total resistance = 3 ohms.Current in the loop = 6/3 = 2 amperesPower dissipated by the 2-ohm resistor - I2R = 8 watts.2). 4V battery, 12-ohm resistor, 2-ohm resistor, all in parallelThe 12-ohm resistor is irrelevant.4 volts across the 2-ohm resistor.Power dissipated by the 2-ohm resistor = E2/R = 8 watts.
The heat anticipator is a resistor that is part of a thermostat control mechanism in some heating systems. It is typically a wire-wound resistor that helps regulate the cycling of the heating system by anticipating the heat demand and shutting off the heating element before the desired temperature is reached.
No, a battery is not a resistor. A battery provides electrical energy, while a resistor is a component that restricts the flow of current in a circuit.
where is the heater blower resistor in a 2003 Honda element
Yes, a resistor has two sides, and furthermore they are interchangeable.
-- If the 3 Amp is being drawn from a battery,then the battery is supplying3 x (Voltage of the battery) watts.-- If the 3 Amp is flowing through a resistor,then the resistor is dissipating9 x (Resistance of the resistor) watts.
Voltage can be calculated using Ohm's Law:Voltage = Current (A) x Resistance (Ω)Voltage = 4A x 3Ω = 12 VoltsTherefore, the battery is a 12 Volts.The power dissipated is Voltage x CurrentPower = 4A x 12V = 48 Watts
you better not. you need a 9V regulator for this, not a resistor!
The voltage of a battery goes as the current times the resistance (V=IR). Because the voltage is being held constant, the resistor that draws the most current will have the lower resistance.
To determine the resistance of the unknown arm of a post office box using the Kelvin method, you need to create a four-terminal connection to eliminate errors from lead resistance. Connect one pair of terminals to the known resistor and the other pair to the unknown resistor. Measure the total resistance, then disconnect the known resistor and measure the resistance again to isolate the unknown resistor's resistance.
In series.
Even though it is connected to a 9 volt source, it is still a resistor.
A rheostat can be used to vary the resistance in a circuit until a balance condition is reached, allowing for the determination of the unknown resistor value through adjusting the resistance of the rheostat until the circuit is balanced. This process is often used in bridge circuits for precise resistance measurements.
That completely depends on the voltage of the battery.The energy delivered by the battery and dissipated by the resistor in one minute will be[ 60 x (Voltage of the battery)2 / 21 ] joules