0
Chevrolet
A brand of vehicle, Chevrolet or Chevy was produced by General Motors Company (GM). The car was named after Louis Chevrolet and was set up to sell a variety of mainstream vehicles to compete with Model T by Henry Ford.
6,429 Questions
What are the different type Chevrolet cars?
There are many different types of Chevrolet cars. They range from small, like the Malibu or Volt, to the large, like the Tahoe and 3500.
Where do you check the transmission oil on a 2005 Chevy Equinox?
You cannot check the fluid level as the transmission is a sealed unit. A GM dealer can check it if you have a leak. If you have no leak then it is fine.
Can you build up a 307 small block motor to 300 horsepower?
in fact u can make a bit over 300 hp and about 325 ft lb. u need heads that will flow better a cam that has good lift and duration a exhaust to help scavange and you will be reving out some serious numbers form that little engine, everyone will tell u to build a 350, but 307s are cheep and respond well to upgrades. and you will be able to cruse with less of a dent in your wallet on fuel cost.
Where is voltage regulator located on 92 Chevy pu?
It is BUILT into the Alternator, It is all 1 unit.
Why is your front end squeeking and abs light on?
You didn't say what you were working on, But it sounds like you have a bad wheel bearing Assembly and the front axel is moveing around and has gotten into the brake sensor sometime are another. Check and replace wheel bearing and sensor as needed.
What causes a four wheel drive vehicle to vibrate while the front axle is engaged?
Bad axel shaft u-joints. U-joints bad in the front driveshaft. It would really help to know the year.
How do you remove 1957 Chevy instrument cluster?
First, pull the steering wheel off and remove the lower cover from under the cluster and remove the lower cover bracket. If it is an automatic, disconnect the shift indicator wire by unhooking it from the right side of the steering column. Reach behind the cluster and unscrew the speedometer cable from the speedo. You should also be able to pull out all the wire connectors from the gauges and the light bulb sockets from the back of the cluster, or you could do it later when you are able to pull the cluster out enough to reach behind it.
Then you have 2 choices: 1)You can unscrew the 3 screws in the turn signal housing and pull the turn signal housing up. This reveals the locking ring the screws were screwed to. So rotate and release the locking ring from the notches in the top of the column tube. Remove the shifter lever and pull the shifter housing up so that it clears the cluster housing. Watch your turn signal and horn wires, since you may have to loosen them to have some slack when you pull up on the turn signal housing.
Or 2) You could loosen the clamp on the firewall from the steering column, and the clamp that holds the column to the bottom of the dash and slide the entire column up enough to clear the bottom of the cluster housing.
Then remove the 4 screws holding the cluster housing to the dash, 2 on top and 2 under each side. There should be 2 nuts to remove from behind the cluster on the bottom. They would be on the 2 long threaded studs that are visible when looking up underneath the cluster.
Pull the cluster away from the dash tilting the top towards you. Pull it out enough to reach behind it, if you didn't pull all the wire plugs and sockets from the back of the cluster before, you can do that now. Otherwise lift the cluster out of the dash.
How do set the timing on a 2001 Chevy 5.3?
It requires an ENGINE SCANNER to set the ignition timing on that year of engine.
What position do you install the cam bearings on a 307 small block Chevy engine?
Turn them so the hole lines up with the holes in the block.
What size engine is 6.0 liter in Chevy?
6.0 liters = 366 cubic inches. This is the Vortec 6000 truck engine that produced from 300 to 345 h.p.
How far can you punch out a Chevy 400 Small Block?
You are better off stroking it. The 400 has 4, and 1/8th inch bore. It also has siamese cylinders to accomodate the larger bore. And, the water does not use water to cool. It has steam holes, as the cylinders are too thin to run watrer, so, remember to have your cylinder heads drilled out for the block. To bore that motor, you would have to sleeve the cylinders, then bore them out. Very expensive.
Where is the ambient air temperature sensor in a 2006 Chevy HHR located?
I see them on alot of vehicles behind the grill area usualy mounted to the core support or bumper reinforcement. So, it will likely be where it has a direct shot of fresh air.
Is roadside assistance available?
Yes, as in all places there are so many auto mobile repair companies are providing this roadside assistance service. You can find one for you through online.
How do you identify the engine of an Chevrolet?
If you are talking about the small block V-8 Chevy engine, there is a small flat pad with an engine id number located on the block, in front and below the passengers side cylinder head. Using that number, visit web Chevrolet engine identification sites to determine which engine you have.
