Cleaning

Start as soon as you can, if the blood dries it is harder to wash. Rinse the stain and then let it soak in cold water. Pretreat it with OxyClean if the stain is stubborn. Wash the clothes on a cool water cycle.

To clean grime off a sofa when using a solvent-based cleaner, you can use a soft brush or cloth to gently scrub the affected areas. Wipe away the grime with the solvent-based cleaner, following the manufacturer's instructions, and allow the sofa to dry completely before using it again. Make sure to test the cleaner on a small, inconspicuous area of the sofa first to ensure it doesn't cause damage.

I did this recently. I was so overcome with the fumes that it caused me to vomit, cough and wheeze heavily! I aired out my house for about an hour. I got out of the house and got some fresh(er) air! That night I slept with my window open to get fresh air all night. It was not until the next day that I felt like myself again.

I gave it one day. But, if I did not clear up, I was going to the emergency room. I read something about chemical pneumonia. So that is my story! Hope it helps!

To remove a Clorox stain, first rinse the stained area with cold water to dilute the bleach. Then, apply a mixture of water and vinegar or a stain remover specifically designed for bleach stains. Launder the item as usual, following the care instructions. Repeat the process if necessary until the stain is fully removed.

Hydrochloric acid is commonly used to clean cement floors due to its ability to dissolve mineral deposits and grime. However, it is caustic and must be handled with care, following safety guidelines and dilution instructions provided by the manufacturer.

Cold water is generally better for treating stains because hot water can cause the stain to set. Using cold water to treat a stain will prevent the stain from spreading and becoming more difficult to remove. It's recommended to treat a stain with cold water first before deciding on the appropriate stain removal method.

just wipe it up with a paper towel, or maybe lots of paper towels. If you use a cloth the detergent could actually stain it. When you have wiped the floor pretty much dry then use wet paper towels to remove all the residue because it may be sticky.

To remove burnt ironing stains from a shirt, mix equal parts of vinegar and water and dab the mixture onto the stain. Let it sit for a few minutes, then gently scrub the area with a clean cloth. Rinse the shirt with cold water and repeat the process if needed.

Irish Spring tends to produce more soap suds compared to Dial because of its unique formula and ingredients designed to create a rich lather.

Suds are formed by the agitation of soap and water, which traps air. Suds can go away when the air bubbles pop or when the soap is diluted with more water, breaking down the bubbles. Additionally, using chemicals like vinegar or lemon juice can help break down suds faster.

By using a filtration process similar to that used in water treatment plants, it is possible to remove the residual suspended solids, including the unsettled microorganisms. Removing the microorganisms also reduces the residual BODs. Conventional sand filters identical to those used in water treatment can be used, but they often clog quickly, thus requiring frequent backwashing.

To lengthen filter runs and reduce backwashing, it is desirable to have the larger filter grain sizes at the top of the filter. This arrangement allows some of the larger particles of biological floc to be trapped at the surface without plugging the filter. Multimedia filters accomplish this by using low-density coal for the large grain sizes, medium-density sand for intermediate sizes, and highdensity garnet for the smallest size filter grains. Thus, during backwashing, the greater density offsets the smaller diameter so that the coal remains on top, the sand remains in the middle, arid the garnet remains on the bottom.

Regular Lysol spray will not bleach colors. But there is another kind of Lysol spray, which has Clorox bleach in it. THAT will bleach colors.

A person who does the laundry is an automatic washing machine. Also known as a laundereror launderette.

To remove dry erase marker from your toilet, you can try using a Magic Eraser sponge or a mixture of baking soda and water. Scrub the marked area gently to avoid damaging the toilet surface. If these methods don't work, you may need to consider using a stronger cleaner designed to remove tough stains.

Brands like Tide, Persil, and Seventh Generation are known for their strong cleaning power and ability to remove tough stains from clothes. It ultimately depends on your individual preferences and the specific needs of your laundry.

You can remove rust stains from a toilet by applying a commercial rust remover or a mixture of vinegar and baking soda. Let it sit for a few hours, then scrub the stain with a toilet brush. For stubborn stains, you may need to repeat the process or use a pumice stone.

the paper towel sucks up some of the water but some sits on top of it, as the towel is saturated and cannot hold more water. Although it will not drip off unless there is to much and it can't be absorbed

Yes, liquid body soap can stain wash clothes if it is not fully rinsed out during the washing process. The ingredients in the soap can leave residue on the fabric, causing stains. It's important to follow the care instructions on the soap bottle and to ensure thorough rinsing when washing clothes that have come in contact with body soap.

A bleach stain on a White t- shirt would just make a hole ! I don't know what your talking about exactly, try soaking the t shirt for a few minutes in bleach, make sure you mix the bleach with the water well before you put your shirt in, that might be how you got 'bleach stains' in the first place (if you just poured the bleach on your shirt and didn't mix it in the water first) and follow the directions on the bottle and don't use too much bleach because that will cause the fabric to weaken and make holes.

I've researched it. American brands have .5% mix of phosphate, while brands in Mexico have 5-7% mix.

For a mix of 1%, half a teaspoon to a cup of detergent would work.

If your locality bans the sale of detergents with phospates, you can add that much to laundry detergent. A small amount should be added to dishwasher detergent.

To clean whites without bleach, you can use hydrogen peroxide or white vinegar. Add a cup of hydrogen peroxide or white vinegar to the wash cycle along with your detergent. These alternatives can help brighten whites and remove stains without using bleach.

For a top loading washer, typically about 1-2 tablespoons of high-efficiency liquid detergent is sufficient for a regular load of laundry. Be sure to check the detergent packaging for specific instructions based on the size of your load and water hardness. Adjust the amount based on load size and level of soiling.

Oxalic acid can be used as a bleach, but it should be handled with care as it is toxic if ingested or inhaled and can cause skin irritation. It is important to follow safety precautions when using oxalic acid as a bleach, such as wearing gloves and working in a well-ventilated area.

If your diamonart is set in sterling silver then yes. I wouldn't clean any other types of metal in sterling silver cleaner. There is a specific cleaner for each metal type because of the chemical reaction.

A solution of half water and Mr. Clean with a small amount of ammonia can be used for all metal types and is safe with all types of fine jewelry. Even pearls, opals, and emeralds.

if you are doing this for a science fair, i did mine this week one that project. you get a syringe, and a cookie sheet, put your amount of water onto the sheet put the paper towel in it let it soak, pick it up, let it drip, then pour the leftover amount of water into a bowl, suck it back up with another syringe. this is a very simple project.