Buick

probably have a loose or broken wire that moves and grounds out when press the brake locate wire and replace it

There are 15 different values: Value: Ohms 02 - 0.523 03 - 0.681 04 - 0.887 05 - 1.130 06 - 1.470 07 - 1.870 08 - 2.370 09 - 3.010 10 - 3.740 11 - 4.750 12 - 6.040 13 - 7.500 14 - 9.530 15 - 11.801 It could be any of those. If you're trying to bypass it doesn't have to be exact but it does need to be close. To make the correct value of resistor, get resistors of different values and add them up. Solder them in-line to each other. If you don't know the correct value start at the bottom and work your way up. There's a 4 minute wait between trys and the ignition needs to go to the OFF position before you start the wait.

Three port holes means V6 engine.. 4 port holes mean V8 engine.

WBS stands for Work Breakdown Structure. It is something that helps breakdown the whole projects scope into smaller and more manageable pieces. This is also a very important process in project management. To be able to actually execute the project, the project scope is broken down into manageable tasks by creating a work breakdown structure (WBS). In other words, a WBS is a deliverable-oriented hierarchy of the work that must be performed to accomplish the objectives of and create the deliverables for the project.

Check the fuses first and the blower relay.

Yes. See the Related Link.

She looks like the victorias secret model

2008 Honda Civic. Great automobile. Dependable, great mileage, roomy, great resale value, and in a car at around $15,000 there is no better.

The typical Buick Enclave has the fuel capacity of most other sedans. The typical fuel capacity is around 16 or 18 gallons.

The firing order is 1-6-5-4-3-2

1982 Lincoln Mark VI (2 door coupe) uses this size of tire. 205/75/15

According to the U.S. Bureau of Labor Statistics the estimated mean annual wage for Automotive Service Technicians and Mechanics as of May 2008 was, $37,540. This would amount to $18.05 an hour.

Error code 42 means a duplicate device was detected. This error occurs when a bus driver incorrectly creates two identically named sub-processes (known as a bus driver error), or when a device with a serial number is discovered in a new location before it is removed from the old location. You may be able to resolve this problem by restarting your computer.

its just a Buick...There is no 4-door Buick Wildcat, at least that's what i get when i Google it.

** Update

Value of the car depends on condition. Some that have been completely restored will go for big bucks. I've seen a 1967 Wildcat convertible for sale for $17,900, but after taking a quick look online I see a price range of approx. $6,000 - $10,000. I wish I could find one in someone's garage!

The Buick Wildcat was the full-size model between the LeSabre and the Electra from 1962 through 1970. In 1967 it sported a 430 CID 4-barrel engine rated at 360 horsepower, enabling the car to live up to its name. It did indeed come in a 4-door hardtop. It came as a sedan and hardtop (2-door and 4-door) and convertible. My family had a 1967 Wildcat, sapphire blue, 4-door hardtop. What a beautiful car! This particular model was renamed Centurion in 1971 through 1973, and then it vanished.

Thank you for posting the update... I actually have sitting in my drive way a 1967 Buick wildcat 4 door hard top. I just wanted to make sure that it was understood that YES there was such a car and she ios Beautiful. One day I will restore her.

You need to go to a parts house and get a power window regulator as it can NOT be fixed.

No Ford has never owned Buick. Buick Motor Company was formed in 1903 and was an independent company. Buick, & Oldsomoblie joined General Motors in 1908.

When an O2 sensor is bad your car will not run efficiently. You will use more gas than you would normally use on a trip.

a huge moter that they put in race car like the chevelle

The 3 hole version was called the Super.

I recently had my harmonic balancer replaced on my 1990 Buick Riviera. When opening the hood, I could actually view the part. It was located on the passenger side of the engine close to other pulley wheels. I googled the part and found it related to cutting down the vibration and stress which may affect the crankshaft. Be aware, I am not a mechanic or guru on vehicles. It cost me around $200 to replace which included the new part and labor. Hope this is of some benefit. BTW, I new something was wrong because it made quite a noticeable sound when starting and when it was in idle.

The 3.8 Buick harmonic balancer requires a special puller. But, if you purchase three 4" long, 6mm diameter, 0.1 thread bolts and three heavy duty washers you can use a standard 3 hole puller to remove the balancer. The threaded holes for the 6mm bolts are about 2" inside the access openings that are located on the face of the balancer. You will need to place the heavy duty washers on the 6mm bolts before they are used with the puller. The hex heads on the bolts are to small for the standard type puller and the washers will support the torque required to remove the balancer. The puller must be the type that allows an extension rod to be added to the center bolt of the puller. This extension is needed because the center bolt of the puller is to large in diameter and it is not long enough to reach the back of the through hole on the crank shaft. (it is drilled very deep). Cost about $2.50, This beats paying over $150.00 for the suggested factory puller.

Depends on what Buick Model and year you are referring to.

Look behind the right front wheel for the tag on the frame. I think it is aluminum.

Generally not, no. However, if you leave the car sitting for long periods of time (several days) or if the wheels are overtightened or if you abuse the brakes this sort of thing can happen.

You can replace your 1998 Buick 3.8 liter engine with a Buick 3.1 liter engine. You will need to change the motor mounts and some of the wiring harness will need to be modified.

Open and read your owner's manual.