Chrysler

No. GM does not own any part of Chrysler.

The 47 is only used in Ram trucks, Dakota's, and Grand Cherokees

The United States of America, Mexico, and Canada.

about 2006

As of right now Chrysler is a private company and does not sell stock.

Gap should be 0.20 if you are regapping old points 0.18 Good luck!

It means nothing it is just the last name of the founder, Walter Chrysler.

That is another name for the under hood fuse box.

Change oil every 3000 miles.

At 100,000, change the timing belt, water pump, coolant, and spark plugs.

Replace the air filter as needed.

The purpose of a panic button on car keys is that if someone is breaking into your car and you see them, you can scare them off and attract attention to them by pressing it.

It's simpler then it looks. Remove the wheel then the brake drum, with a flat head screw driver remove the dust cover. you will need a large socket to remove the nut. I bought one at Auto Zone I beliieve it was a 36MM but the package says earley Chrysler Front hub nut socket (same nut for the rear) after removing the nut the hub and bearing asy will slide off. When putting on the new hub make sure you grease it with bearing grease

2005

Solenoid switch valve latched in the low reverse position. You either have a failed solenoid or a stuck valve in the valve body.

Yes

It's estimated to come out in 2 to 3 years. However the current design could change. Also if the design doesn't change it is estimated to cost between 50 and 60k

1,2,3,4,5,6

1,2,3,4,5,6

NO. If the camshaft is broken it will not run. If the camshaft is worn it will run poorly.

Pay attention and take notes during the lesson portion of this class.

It went over 200mph., at Talladega in the Superbird. Dodge did put out a bulletin to the dealerships about how ther motor was not intended for constant high rpm use, and any such behavior would instigate overheating, which is funny, because that was supposed to be a NASCAR motor. It really wasn't designed for drag racing, which is what the "max wedges" were for, super stock, eliminator. The Hemi was not impressive, at all, on the drag strip, and NASCAR, outlawed it right away, but not before cutting loose, and shattering all kinds of track records. If fact, though we would have arrived here eventually, anyway, but, that motor pretty much is responsible for the restrictor plates, of today. Although not required til years later, that kind of gave NASCAR an insight to where they were headed. It directly led to the lower cid requirements, ofr 355. And so, years later, when Bill Elliot crossed that 200 mph's mark, they were ready.

Most Chrysler transmissions do not have a drain plug.

I paid roughly $600-$650 for the whole repair.

The oil pan is at the front of the engine just behind the cross frame. The oil plug faces the passenger side of the car.

Valves can bend if the timing belt breaks, so it is interference.

At the end of 2009 there were 59,000 employees.