answersLogoWhite

0

🚗

Chrysler

This category is for questions and answers about Chrysler corporation vehicles.

1,889 Questions

Is there a way to clear obdc codes in Chrysler PT cruisers without a scan tool?

Yes, you can clear OBD-II codes in a Chrysler PT Cruiser without a scan tool by disconnecting the vehicle's battery. To do this, remove the negative battery terminal and leave it disconnected for about 15 minutes. Reconnect the terminal afterward, and this should reset the engine control module and erase the trouble codes. However, this method may also reset other systems, such as the radio and clock settings.

Are Chrysler and Chevy the same company?

No. Chrysler is part of FCA, Fiat Chrysler America. Chevy is part of GM, General Motors.

Where is the transmission dipstick in a 2006 Chrysler 300?

The dipstick is a special tool. The dealer and some transmission repair shops will have it.

Is Mitsubishi owned by Chrysler?

No. Mitsubishi is only related to Chrysler by 35% of their vehicles, but it is not owned by Chrysler. Mitsubishi is owned by European FC Truck Motor Company.

Will a 5.7 hemi fit a 4.7 transmission?

Doesn't matter if it does or not... that 4.7 transmission isn't built for the torque output of the 5.7, and all you'll accomplish is to destroy a transmission.

Is Hyundai part of Chrysler?

No. Hyundai is its own company. Hyundai owns KIA. Chrysler, owned by Fiat Chrysler Corporation, is another separate company that currently only owns Dodge and Jeep, and previously owned Plymouth, Eagle, and Desoto. Hyundai is not part of Chrysler.

Are Chrysler Jeep and Dodge the same company?

Yes, Chrysler and Dodge are the same company and owned by the Chrysler Group LLC. Jeep was bought by the Chrysler Group LLC in 1992, but Jeep is not originally the same company as Chrysler and Dodge. Jeep is also originally considered another separate company.

How do you program a 2011 Chrysler Town fob?

To program a 2011 Chrysler Town & Country key fob, start by sitting in the vehicle with all doors closed. Insert the key into the ignition and turn it to the "On" position (without starting the engine) three times, ending in the "On" position. This action will put the car into programming mode. Press any button on the new key fob within 30 seconds to program it, and the locks should cycle to confirm successful programming. Repeat for additional fobs if necessary.

Where is the bulkhead connector located on 1994 Chrysler Concorde?

where is the bulkhead connector located on 1994 Chrysler concorde

Where is thermostat on a Chrysler LeBaron 2000?

There wasn't a 2000 LeBaron. On a Lebaron, the thermostat is under the housing where the upper radiator hose attaches to the engine.

Can you eliminate the egr on a 1973 318 Chrysler motor?

can you eliminate the egr on a 1973 318 chrysler motor

Are there 2 thermostats on a 2.7 Chrysler motor?

No. The 2. 7 L V6 has one thermostat located where the lower radiator hose attaches to the engine.

Where are the oxygen sensors on a 2005 Chrysler Town and Country?

There are two oxygen sensors. One at the inlet and one at the outlet of the catalytic converter. The catalytic converter is behind the engine.

What could be wrong with my 2006 Chrysler Town and Country minivan The air conditioning is not working?

I was told my rear evaporator needs replacing on my '06 T&C as well, an $1,100 fix, and the parts are on huge back order, so a long wait. It is out of warranty.

I took it to a trusted mechanic, and he said there's another option -- disconnect the rear air and recharge the system, just use the front a/c. That was done, and so now the front air works fine. It just takes a little longer to cool the back. The fix was only $375.

The van is out of warranty, and I didn't want to pay $1,100 for a rear evaporator for fear it might happen again because I've heard it's due to vibration and possibly a design defect.

No recall by Chrysler so far. They should take responsibility for this. One dealer I called said there are 4,000 requests per week for rear evaporators, so it's a common problem.

Rear air was not standard in minivans in the past, so it's not so awful to be without it.

Where is the transmission dipstick on 2006 Chrysler 300?

On a 2006 Chrysler 300, the transmission dipstick is located towards the back of the engine bay, near the firewall. It's typically found on the driver's side, next to the engine and close to the transmission. To access it, you may need to remove any engine covers or components that obstruct your view. Always ensure the vehicle is on a level surface and the engine is warmed up before checking the transmission fluid level.