What is the cause of Cyclone Yasi?
Cyclone Yasi was caused by a combination of factors, including warm ocean temperatures, low wind shear, and the monsoon trough in the region. These conditions provided the necessary fuel for the storm to develop and intensify into a powerful cyclone.
There are two main factors consistent with the formation of all cyclones:
What were the wind speeds in cyclone yasi?
220 k/ph was the average, but it reached as high as 290 k/ph.
Where did Cyclone Yasi get its name from?
Severe Tropical Cyclone Yasi was given its name in Fiji. The cyclone started as a tropical low near Fiji, and when it was upgraded to a cyclone, it was given a Fijian name by the Fiji Meteorological Service.
Severe Tropical Cyclone Yasi was given its Fijian name because it developed in Fijian waters. The cyclone started as a tropical low near Fiji, and when it was upgraded to a cyclone, it was given a Fijian name by the Fiji Meteorological Service.
Cyclones usually travel over ocean waters on an average of 300 to 400 miles a day. They are the most strongest then, but when they travel over colder ocean waters or land, they will begin to weaken.
Mine would do 110 km/h on pavement if there was no wind. It also reaches this speed in about 12-14 seconds.
Cyclones form and occur in a variety of areas around the world. "Cyclone" is the generic term for cyclones, typhoons and hurricanes. Cyclones develop in the warm seas near the equator, but do not cross the equator. Those in the Southern Hemisphere are usually known as cyclones, but cyclones in the China Sea region are often called typhoons, whilst those in the Americas and the Atlantic Ocean are known as hurricanes.
Cyclones are prevalent in humid, tropical, warm to hot regions. They require a minimum sea temperature of 26.5 degrees Celsius in order to form. They do not usually occur north of the Tropic of Cancer or south of the Tropic of Capricorn as the sea temperature is not generally high enough to support the development of a cyclone. There are always exceptions, however, and in Australia they have been known to move south of the Tropic of Capricorn after forming further north. This is because they follow the warm water currents.
How do you prepare for a cyclone?
Board up the windows, find a safe place or leave, depending on your situation. Have canned food and bottled water if you stay and hope for the best.
Further information:
Emergency Management Queensland's website offers the following advice for basic action before and during a cyclone:
Once a cyclone hits:
Click on the link below (Cyclones in the Northern Territory) for full information to guide you through this process.
What are some facts about cyclone yasi?
Cyclone Yasi was a severe tropical cyclone that struck northeastern Australia in February 2011. It was one of the strongest cyclones to ever hit the country, reaching a maximum intensity of Category 5. Yasi caused widespread devastation, damaging homes, infrastructure, and agricultural crops in the region. Despite its strength, there were no direct fatalities reported as a result of the cyclone.
Was Cyclone Tracy worse than Cyclone Yasi?
It is difficult to directly compare the severity of Cyclone Tracy and Cyclone Yasi as each cyclone had different impacts and affected different areas. However, Cyclone Tracy, which struck Darwin, Australia in 1974, caused more loss of life and extensive damage to the city compared to Cyclone Yasi, which hit northern Queensland in 2011. Both cyclones were significant in their own right, but Cyclone Tracy is often considered one of the most devastating cyclones to hit Australia.
How many people were injured by cyclone yasi?
Cyclone Yasi, which struck Queensland, Australia in 2011, resulted in no reported deaths, and only a few minor injuries were reported. The timely and comprehensive evacuations and preparations carried out in response to the cyclone likely contributed to the minimal injuries.
Where did cyclone yasi take place town or city?
Cyclone Yasi travelled through more than one country. I'm in the Solomon Islands and it hit parts of this country, and then went to Australia (the state of Queensland). Australia was the last country it hit. I'm not sure where it was before the Solomon Islands..... maybe Fiji.
Where did cyclone Yasi finish?
Cyclone Yasi made landfall near Mission Beach in Queensland, Australia on February 3, 2011. It then moved inland and dissipated over the Northern Territory.
What was cyclone yasi death toll?
Cyclone Yasi, which hit Australia in 2011, caused the death of only one person directly attributed to the storm. However, it resulted in significant damages to infrastructure and homes in affected areas.