Why does a 2001 dodge Cummins have no smoke?
It is not meant to smoke. It is running properly if there is no black smoke.
It is not meant to smoke. It is running properly if there is no black smoke.
Where is the bank 1 sensor 2 2000 dodge caravan?
It is screwed into the exhaust at the outlet of the catalytic converter.
It is screwed into the exhaust at the outlet of the catalytic converter.
Is a 2006 dodge charge front or rear wheel drive?
Rear wheel with an option of all wheel drive.
Rear wheel with an option of all wheel drive.
How do you change blend door actuator on a dodge Dakota?
The blend door actuator on late model Dodge Durango and small pickup can be accessed by removing the glove box. There is a very common problem with blend door failure in these vehicles, and dash removal is required to perform the repair. A cheap and easy DIY fix for this can also be found at heatertreater. They also make a heater core regulator which bypasses the blend door and can remedy the situation with no dash removal.
Where is the block heater cord on a 2011 dodge 5500?
You had to buy the cord separately unless it had the cold weather package. Once installed it should be on the front pass side.
You had to buy the cord separately unless it had the cold weather package. Once installed it should be on the front pass side.
How do you know if a 2004 dodge stratus has variable valve timing?
It doesn't. It wasn't an option.
It doesn't. It wasn't an option.
Is there more than one way to install the distributor gear in a 1997 Dodge Magnum 5.9?
disconect neg battery cable. some people put the engine on top dead center, some people just mark where rotor is pointing and mark distributor.at base of dist, there is a screw holding a wedge to hold dist tight remove screw and wedge,,, remove hall effect connector (pick up coil cam sensor get dist on bench look at bottom gear you will see a pin that goes thru gear into shft these is called a roll pin. in must be removed with a dowek pin remover ive seen peolpe use a cut drill bit of correct diameter. once pin is out slide gear off shaft. if it does not move spray carb cleantr and let sit for a few minutes. enginge sludge turns to varnish and freezes gear ... if you find roll pin is sheared when you pull out dist it means you have a frozen oil pump. if gear is chipped chances are you camshaft is damaged you can look down in hole to check cam gear for damage
Can you use a 10w30 oil in your Dodge Caliber?
No, it requires 5W20. Using 10w30 would cause improper operation of the variable valve timing system.
What is trouble code P0420 on a Dodge Caravan?
P0420 is bank one catalytic converter efficiency failure.
Highly doubt in america, maybe assembled here, but all components are most likely made in foreign countries.
Does 2005 Dodge Ram 1500 use a speedometer cable?
No, signal comes from the abs wheel speed sensors.
No, signal comes from the abs wheel speed sensors.
Which cylinder of a 1969 dodge 440 is?
Pass side 2-4-6-8
Driver 1-3-5-7
Pass side 2-4-6-8
Driver 1-3-5-7
How do you locate crank shaft sensor on 1986 dodge ram?
It only has a pick-up plate inside the distributor.
It only has a pick-up plate inside the distributor.
Who is the transitowne dodge girl?
Yes she is Kristen, Local girl that grew up West Seneca had never done acting but does a great job !