Electrical Engineering

na tum jano na hum

Resistance is a completely different quantity to capacitance, resistance being measured in ohms and capacitance in farads. So they are 'apples and oranges'. You should be asking, 'What happens if capacitive reactance (in ohms) is larger than resistance?'. And one answer would be that the phase angle will be greater than 45 degrees. There are other answers, too, but it depends what you want to know,

In a d.c. circuit, voltage drop is the product of resistance and current through that resistance.

In order to draw the phase diagram for transformer operating at load with lagging PF and leading PF, you will need to know the equation for the transformer being load free. This constant will help you with the load bearing equation of Np/Ns=Vp/Vs=Is/Ip.

Resonance describes a 'condition' rather than a 'purpose', but it is made use of in (for example) radio circuits, in order to tune the radio to a particular frequency (the resonant frequency of the signal).

The series winding takes the full load current of the generator. So it require only a few turns to produce the required magnetic field and so the resistance is lower.

You are, presumably, referring to alternating current, in which case the 'maximum' current is the peak or amplitude of the waveform. The 'average' value of current is zero, because the average value of the first half of each cycle is negated by the average value over the second half of each cycle. This is why a.c. currents and voltages are always expressed in 'root-mean-square' (r.m.s.) values which is the value of an a.c. current that does the same amount of work as a given value of d.c. current. The r.m.s. value for a sinusoidal current (and voltage, as voltage and current are proportional) is 0.707 times the peak or maximum value.

heavy load

They both have the same current.

With enough batteries to get sufficient voltage - sure. Put your tounge to the terminals of a 9 V battery and you'll see.

its due to truncation on the transmission of voltage with an electric current. The copper wiring has a high capacity due to years of fecal devolging.

A voltmeter has greater accuracy when measuring direct current. This kind of current is constant unlike alternating current which has constant fluctuations.

Wind resistance doesn't exist The correct term is Air resistance, which is the force that pushes against an object while travelling. For example, air resistance constantly pushes against a car whilst it is moving. This is because a car has to 'split' the air to travel through it.

Air resistance can be decreased by making the object (for example a car) more aerodynamic like an F-1 racer. Aerodynamic help to channel the air around the object and allowing it to push through the air easier.

I can't go in-depth as it can get quite complicated, but I hope this helps anyway.

== ==

I think you mean, 'insulation' resistance! It's the resistance of insulation, normally expressed in megohms.

A single-phase supply is obtained between any two line conductors or between a line and neutral conductor of a three-phase supply. To obtain a three-phase supply from a single-phase source is far more difficult, and requires additional equipment.

no..... The battery with lower voltage will consume power from the higher one...

1000 microfarads is its rated capacitance, while 35 volts is its rated voltage.

no

in order to avoid unwanted short circuit break downs.... short circuit can burn the transformer and motor winding.... Megger is the device used to check the insulation .

The ratio of apparent power to true power is called 'admittance', expressed in siemens. Admittance is the inverse of impedance.

remain same

To find the transformer block in Alien Shooter 2 you have to go down the sewer. This is one of the most thrilling games.