Fiat

theres a small panel that removes just above the small shelve on the right just below the steering wheel remove panel and plug is at the top

Fabbrica Italiana Automobili Torino (English: Italian Automobile Factory of Turin)

It has 90 hp

what is the weight of fiat ducato 2.8

Remove caliper backing plate that is attached with 4 10mm bolts. Two above the caliper on backing plate and two below. Remove tow caliper mounting 17mm bolts and slide caliper out. Remove rotor retaining studs and remove rotor. There is a internal C-Clip inside axle housing behind flange that you must remove. Must have a GOOD pair of 90 degree snap ring pliers. Once clip is out you use a slide hammer attached to wheel bolts and remove axle. Good Luck.

the oil required is 5w30

Yes the car floats

orange light that looks like a cylinder

How Do You replace the hand brake lever on the South African (Nissan Build)

Uno 1100 Fire (1992 Model) 1108 cc Engine Spec?

The Handbrake Lever doesn't hold up into the Ratchet part anymore and doesn't stay up when handbrake applied as the parts are worn down over the years.

I tried Banging out the Pivot at rear of the handbrake lever but can't see what holds the pin in place and wont move, Is there a Split Pin Or Washer Holding it?

Thanks Walter

$5

This is a job for at least an apprehntist grade mecahanic. Start with the wheel cylinder furtherest away from the master cylinder, the right rear. With the brake master cylinder full of fuel have a second person pump the brake pedal a few times until a little pressure is felt at the foot pedal. At this point the pedal should be held to the floor while the bleed niple on the cylinder released. This process should be repeated until the fuel comes clear of air. Move on to the left rear cylinder and repeat the process then on to the front right and fiinish at the front right.

Be mindful that if the vechicle is a left hand drive the bleed process should be left rear then right rear on to right front then left front. The rule is always start with the cylinder furtherest away from the master cylinder and finish at the cylinder closest.

Easy, Put the key in the ignition, don't turn it, push the trip button under the speedo and hold it in the pushed position while you turn on the ignition. You will see the display count from 10 down to 1 then you can stop pushing. Job done, service interval reset.

Turin, Italy

yes, actually i removed this on my fiat uno a month ago and it work better now than abs is attached

Where is the glowplug relay on a fiat ducato 2003 1.9

Italy

It asked the same question a couple of years back and the response was that it was very difficult to get a good indication of the oil level. The best idea is to drain and refill it.

if all you have is a motorcycle liscense,you figure!

The world, creation, fiat means to command something to be done and have it doen without effort or even material. "In the Beginning God created the Heavens and the Earth.....""...... He commanded, let there be light, and there was light, and he saw that it was good." and so on. does that help?

Most of the fuses for lights are behind the glove box that pulls down on the passengers side. You need to pull it forwad of its normal stop position and the fusebox is on the back of the engine compartment.

About $4,000

The wiper relay sorts out the intermittent wipe and the parking of the wipers it's blue 6 pin it's right hand side of fuse box behind glovebox :)

Fiat is an Italian company which makes cars and so will not be a French icon.

under and back of the right front light

according to the Peter Russek pocket mechanic Manual it says 10w40 or 15w40