Honda Pilot

Trouble code P0154 means: O2 Circuit No Activity Detected (Bank 2, Sensor 1)

You need to first remove the rear wiper blade. To do this pop off the end cap and remove the 10mm nut from assembly. The next step is to remove the larger nut(I used 23mm deep socket) with the correct size socket or wrench. This nut can be really hard to remove is it is rusted. After that you will need to open the rear hatch and first remove the handle on the lower right hand side, two phillips screws inside the tabs. Then you will be able to pop off the lower portion plastic trim(carefully). Next step is to undo the wiring harness, and then remove three 10mm bolts holding the motor assembly and pull out the whole assembly. To put in new unit reverse steps. Good luck.

The ground clearance of the 2010 Honda Pilot is 0 ft. 8 in. (8 in.).

Under the center console on the passenger side. You need to remove the lower panel on the passenger side of the console and then you can get to it. It's best to use a T25 torx bit to get it out as well.

The 2007 Honda Pilot has a 5-speed automatic.

Auto Transmission Fluid

This light could be on due to a defective fuel cap.

it the engine code. 2 rotor, naturally aspirated rotary

See Honda Pilot dot org.

http://www.hondapilot.org/forums/showthread/t-20409.html

You must insert the 5 digit code. It came on a small white sticker with the car when new. Look around for the code. Look in the owners manual and anywhere else it may be. Inside the glove box, etc. If you cannot find it go to the Honda Owners website and register your Honda. After registering your vehicle you will be able to get the code for free. Click the link.

The 2014 Honda Pilot has a 3.5 L base engine size.

Honda says use 5-20 W oil for this car. You can use Honda car engine oil, it is synthetic and produced by Exxon Mobil. You can also use other brands of similar quality.

Edmunds is a very reputable website that provides users with the opportunity to read reviews on any car. These reviews were submitted by individuals who own the 2009 Honda Pilot, and can give first hand insight on it.

To replace the speed sensor on a Honda Pilot you first need to research it. There are two speed sensors on the Honda Pilot. One is on the transmission the other is on the left front wheel. To replace the one on the tranny all you do is unscrew it. To change the other you have to remove the wheel, brake caliper and caliper bracket. Then you remove the hub. Then you pull it out.

Google Honda pilot block heater. There is a parts dealer that includes installation instructions showing where the plug is to drain the coolant. This is where the block heater screws in, replacing the bolt.

The driver's power window in the pilot has an auto up/down function, the rest do not. To use this, pull/push the window past the first 'stop' and if you let go, it will go all the way up or down automatically.

FIX:

1. Start the car and leave it idle.

2. Hold the window button down all the way, until the window is completely down.

3. Let go and push it down again and hold the window button for 2 to 3 seconds then let go. (You should be able to hear or feel (very faintly) the motor/sensor reset.)

4. Pull up on the window button and roll the window up until it is all the way up, when it is up let go.

5. Pull the button up again for 2 to 3 seconds. (You should be able to hear or feel (very faintly) the motor/sensor reset.)

The 3.5 L V6 in the Honda Pilot has a cam belt. It MUSTbe changed at 105,000 miles as this is an interference engine.

1=Rotate tires and check air pressure and condition of tires.

2=Replace engine Air filter & Cabin filter, check drive belt.

Check the inside of the door. There should be a label there. I think it is 32psi but check the label.

The height of the 2012 Honda Pilot is 5 ft. 11 in. (71 in.).

17mm socket will work fine

A 1 Honda Civic 8th Gen. : Oil change + Tire rotation

To open a Honda Pilot hood, start by locating the hood release handle beneath the dashboard's left bottom side. Then, go to the hood, and place your fingers under the center edge of the hood. Feel around for the hood latch handle, which is slightly to the left. Once you find that, push it up until the hood releases, and then lift it up.

The curb weight of the 2013 Honda Pilot is 4306 lbs..

What I found was

P1459 EVAP Emission Purge Flow Switch Malfunction

It could be part of the vacuum circuit that purges gasoline fumes from the fuel tank.