Honda Pilot

Press and release the unlock twice. Then press and hold the unlock button. Wait a few seconds and the windows will start to go down. They will continue to lower as long as you hold the unlock button.

It means the Honda Dealer will charge you $300+ to just check a bunch of things

There have only been 2 generations of the Honda Pilot. The 2nd generation was launched in April 2008. It was given a face-lift in 2012. This generation is still in production as of the 2014 model year. When Honda with launch the 3rd generation is unknown at this time.

The EPA mileage estimate for the 2006 Honda Pilot is 16 mpg in the city, 22 mpg on the highway.

In a 2003 Honda Pilot it is normal for the radio to stay on for up to 15 seconds as programmed in the multiplexer module. However, if the radioÊis on for more than a minute, there is a stick relay problem.

Make sure you put it in the CD player, my wife thought she put one in but had actually pushed it into a small gap just above the CD player.

Try P235/70/R16, that is what came from the factory.

what does code b 124 mean

I am not sure about the 2007 model.

2004-200 Models:

The answer is in the manual.

If you do not have the manual:

After you turn on the engine, hold the trip reset button until the service remainder resets.

The Honda Pilot is built in Lincoln, Alabama, and was also produced in Alliston, Ontario, Canada until April 2007. Pre 2008 built in Canada, current model built in the US.

The 2004 Honda Pilot has 41.9 in. of front head room.

The height of the 2010 Honda Pilot is 5 ft. 11 in. (71 in.).

The EPA mileage estimate for the 2011 Honda Pilot is 17 mpg in the city, 23 mpg on the highway.

VTM-4 available from Honda only

Type your answer here... How to Replace a Lock Actuator | eHow.com go to eHow.com and type in Replace Honda pilot door Lock Actuator replacement

A= Replace Engine Oil

1= Rotate Tires

2=Replace Air Filter, Cabin Air Filter, Inspect Drive Belt

3=Replace Transmission Fluid

On page 313 of the 2008 Honda Accord Owners Manual

To remove the door panel from a 2003 Honda Pilot all the mounting screws must be found and removed. There will be 2 screws and 8 clips holding the panel to the door. After removing the screws the door panel will be able to be pulled off.

The 2013 Honda Pilot is 15 ft. 11.4 in. (191.4 in.) long.

behind the glove compartment

I think you're looking at the low tire pressure indicator, which is just to the left and below the 'C' on the engine temperature gauge. See this page:

https://techinfo.honda.com/rjanisis/pubs/om/TW0606/TW0606O00062A.pdf

7

Check your manual, but I believe this lets you know that you need to have routine maintenance performed in the near future. Once the light remains on / does not go off then it's time for service.

if it is the remote keyless entry on the key fob that you want to reprogram you can do that yourself. Most Honda dealers will program the keyless remote for free. you can do it yourself if necessary. to program the remote you follow this procedure

you need to sit in the drivers seat with all of the doors closed for this programming procedure to work. leave the doors unlocked when you start the procedure.

1. put the ignition key in the ignition but do not turn it on. hold the remote to be programmed in your left hand.

2) with your right hand, turn the ignition key to the ON position so that the lights on the dash come on. you do not need to start the car. within 3 seconds, push the lock button on the remote in your left hand.

3) turn the ignition key to the off position. then turn the ignition key to the ON position agai. within 3 seconds press the lock button on the remote. then turn the ignition key OFF.

4) repeat that procedure 2 more times. on the 4th cycle you should hear the transmitter operate the door locks. and the doors should lock. then use the remote to open the doors.

5) if you have a second remote, use it to open and lock the doors

6) after that, turn the ignition key to the OFF position. your transitter will be programmed to the vehicle.

2007 pilot passenger side fuse box, located on scuff panel, fuse nr10 15a

I have the same problem - I was recommended a brake fluid drain and brake fluid sensor replacement - haven't done it yet, but hopefully it works. Dealer quoted me $190.