answersLogoWhite

0

🌼

Interior Design

Planning the furniture placement and layout of the inside of a building is what Interior Design is all about. It is the branch of architecture that deals with the selection and organization of furnishings for an architectural interior.

5,109 Questions

Depth of bar counter?

12 to 18 inches deep 36 to 42" high

48 square meters how many meters?

It is an area not a linear distance. It could be 4 m by 12 m or perhaps 6m by 8m or any value x m by y m wherethis constraint holds true.... x*y = 48.

How many metres in 10 feet?

33 feet because there's 1 meter in 3 feet

Direct Conversion Formula 10 m*

1 ft

0.3048 m

=

32.80839895 ft

What does bylevel mean?

A bi-level property is one where you have to go up or down stairs to get to any floor. The properties are cheaper than 2 story houses.?æ

In simple terms what are fully vitrified tiles?

Vitrified tiles are made by combining 40% clay and 60% silica in a process called vitrification. The process of manufacture makes them extremely hard and non-porous - a great advantage over natural stones like marble which are porous and hence need a good deal of care. Vitrified tiles are virtually maintenance free and have very good abrasion resistance - which makes them very suitable for use in high traffic areas. And there is another huge advantage vitrified tiles have over most other floors. The designs on vitrified tiles are printed with soluble salts which are essentially penetrating pigments that penetrate to a depth of 2 to 3 mm below the surface of the tile ... and that means the design is present at depths of up to 25% of the tile's thickness! And the high hardness and abrasion resistance of vitrified tiles essentially means that the design is permanent for all practical purposes. In contrast, some floor polishes exist over the surface of the floor and have little abrasion resistance. But on the other hand, vitrified tiles are not currently available in a great variety of shades - at least not in as many shades as natural stone tiles are.

How do you convert measurements to square feet?

Convert feet to inches and fractions to decimals-multiply the length times the width and divide by twelve

How tall is 3 stories?

It varies. Some have 8 foot ceiling with 1 foot floors=9 foot some have 8 foot ceiling with 2 feet floors=10 feet

What is the average cost of laying a new asphalt driveway?

Current rate 1.50/square Foot. 8-22-08

HOW MUCH FOR A 33 X 33. NEED TO TAKE OUT EXISTING DRIVEWAY.(DIRT)

The current rate in Texas is between $3.00 and $4.00 a square foot. To install new asphalt at approx. 2 inch depth. You will need to figure in the base and tear out of the old asphalt as well as disposal fees. Don't forget the price of gas. Diesel fuel is up pretty high. Oh and Uncle Sam too! This is if you want a reliable contractor.

Some of the smaller freelancers will charge less and do good work too! Never advance more than 50% for the job. That is more than enough for any asphalt contractor to get the job done.

How many trusses do you need for a 30wx45lx15h garage?

For a gable end to gable end installation on 16" spacing you would need 34 trusses, 2 of which would be the gables. If your roof-line has hip ends or will be incorporated into an existing structure there will be more trusses.

When were Venetian blinds invented?

December 11, 1769 - Edward Bevan patented Venetian blinds in London, England.

August 21, 1841 - The first U.S. patent for a venetian blind was issued to John Hampson of New Orleans, LA on a "manner of retaining in any desired position the slats of Venetian Blinds"; first U.S. installation of Venetian blinds supposedly was in 1761 in St. Peter's Church, Third and Pine streets, Philadelphia, PA.

How much does foundation repair cost?

Foundation repair costs varies. Some repairs may be as much as $30,000. You will need to get an estimate from a professional.

How many gallons of paint are required to cover 179.18 square feet?

To paint 180 square feet, generally about 3 quarts of paint would be required. However, this figure varies depending on how many coats are applied.

What are the ingredients for making artificial stones?

To make artificial stones, a substance is usually poured into a mold. Cement or resin is sometimes used to make artificial stone.?æ

What are some ways particle board is used?

Particle (MDF) board is used for making doors, partition & some furniture like shelves.

What determines a house is 1.5 stories?

The location of the bedrooms determine whether a house is 1.5 stories. If all of the bedrooms are located on the second floor it's called two-story; if the master bedroom is onthe main floor, it is called 1.5 stories.

Building a new bathroom?

yes, with a toilet,shower and wash basin

Cost per square foot to build a new home in Portland Oregon?

The approximate cost to build a single-family home in Portland, Oregon, is $120 per square foot. The larger the house, the less per square foot.

What is a walk up apartment?

It is an apartment that you must use strairs to access; that means no elevator.

During what era did marine life become diverse?

The Paleozoic Era, because rich fossil evidence displays that early life in the time of the Paleozoic Era, there existed a dicersity of marine life.

What is the standard height for bathroom wall tile?

Just under outlets and switches and just above vanity so any border is at top of vanity backsplash or more than half of a field tile so it is not an eyesore.

What was old ceramic pipe used for?

Drainage, sewerage, nearly every thing that P V C pipe is used for today

What is a thick velvety fabric used for carpets and upholstery?

Good MOrning, Just came accross this site; very interesting. The answer is MOQUETTE.