John Deere

It's a lawn tractor.

get smaller couplings and lign everything up and attach

Yes!

I was offered 5000.00 up to 6000.00 for a john deere A wide front end tractor with a log hitch on the back .I just traded my 30/30 marlen for the tractor and was removing it from the junk yard it was in and a man offered cash.this was in october 15 2009. 5000.00 not runing and 6000.00 runing .

The first diesel tractor was made by German manufacturer Benz-Sandler in 1922

John Deere died on May 17, 1886, at the age of 82.

bladebelt diagram for john deere stx38 yellow deck

engine oil for JD gator ?

The steel plow was used to turn the top layer of soil, covering up the previous years plant matter and giving the farmer fresh black soil for the next years crop.

I think this is a model X475 made in 2004

a latar mode 1050 (after they went to a better seal on the front drive axels) is worth 10,000 to 12,000 if it has less than 3000 hours, and is in good repair.

I can not find one either

I'll try to give you an unbiased answer...John Deere. I have farmed with many colors of tractors varying from green to red and even a little orange and gray but over the years I have found that John Deere does make the best tractor. They rarely have mechanical problems but if you do they have a virtual army of skilled mechanics to stand by you to make sure it is fixed. No company other than John Deere has remained under the same name for 172 years like John Deere has.

40:1

check the torsion dampener.

i need a diagram for installing a belt on a john deere lawn mower 330

The trans/hyd filter is located in the left side of trans.case,below the battery. You will need a 3/4" wrench to remove cover retaing bolt.put a oil pan under when you change, for you will loose a small amout of oil from the cover when removed.

You can try: http://www.deere.com/en_US/homeowners/services_support/manuals.html

According to TractorData site (http://www.tractordata.com/lawn-tractors/000/5/8/585-john-deere-345.html) That is a 1996 model.

I got mine from the local dealer. Got a full parts manual too.

the rear hydrolic pump doesn't have much pressure on my John Deere 3140, does the cab have to come off? How do I change the o rings?

You should be able to go to the website and find your tiller in the parts search area

I know this is an old question but I searched for a few hrs trying to find the answer to this and I saw where some had taken the clutch assembly off which is what I was going to try until I talked to my neighbor, and he just replaced his on his craftsman and it hit me, that's what I need to try...

I started off by taking the deck off, then I unplugged the clutch assembly harness, I loosened the small spindle and shield by the clutch assembly, I took off the spring on the tensioner as well as the shield on the 2 tensioner spindles, then I fed the belt on the clutch side spindle first then I fed it in the little metal wire type guide, then in between the fan blades on the rear hydro side and just spun the fan blades slowly to feed the belt down and onto the rear spindle, I then lined it up inside the tensioner spindles and reinstalled the shield and spring then fed it inside the small guide spindle and shield and tightened it down then reconnect the clutch wire harness and your back in business! Hope this helps!

the green mower store .com go to parts search