Lexus

To remove the radio check this link out. It gives instructions. www.installer.com/pdf/95-8152.pdf

there is a box under the driver side of the hood, and also a box above the pedals inside on the drivers side

It's right on the front of the engine. Two bolts hold the housing on. Use an OEM thermostat around $25 to $30, and a new o-ring that goes around the new thermostat. You should drain 1/2 to 1 gal. of coolant before you start. Top up the reserve tank when you're done (DO NOT OVERFILL).

On my RX 350 and Craftsman opener I just pushed the memory button on the Craftsman opener briefly (the signal light came on next to the button) and

released it. Then I pressed the sender in my car within 30 seconds. It wasn't

long before the lights on the opener flashed and I then released the Lexus button.

Didn't have to hold anything down very long at all.

Stock: 215 hp -Airekah This may be what both engines produce at the crank on 91 Octane fuel. At the rear wheel the automatic will give about 160 hp and the manual will give 180. A bit more on 93 octane, maybe another hp or two.

You can, but not very much. May be like 4 or 5 gallons at most

Well, you have 2 keys. one remote with buttons and one valet key with no buttons and no remote controls. The one with buttons have 2 forms of programming required. First, for the remote function to control the doors and/or windows, the second to start the car itself with the key in the ignition. You can program the remote function yourself with a door procedure, however ,the key itself can only be programmed by the dealer for the car to start. The same programming applies to the valet key.

The song was done by Kael Alden composing for Robot Repair...check their stuff out here:
http://www.robotrepair.net/
//tk


If you like this kind of music check out Kael's band "Faded Paper Fingers" on Myspace.
Kael was the composer for this commercial and his music sounds a lot like this! Their first album is coming out soon! WOOO HOOO!

The name of the song is "Where You Belong" and you can get the full version here:
http://www.robotrepair.net/public/Where_You_Belong.mp3

The fuel capacity for a Lexus LS400 is 22.5-gallons. The low fuel light comes on when there are around 2-gallons of fuel left in the tank. The Lexus LS400 gets around 24-mpg on the open highway.

Sad to say, but you can't reset it due to the fact that the bulb itself has to be of OEM spec (same power output). So you can't just go to autozone and expect to buy some LED ones to replace it with your old ones so the resistance of the bulb does really matter but overall it will turn itself off with the correct type of bulb. Hope that answers your question and good luck!

if u just drain and then refill it.. and u have a 98-05 GS then u refill it with 2.5qts from the Lexus standard

Sledge hammer and a dent puller.

Check the relay, there are 3 drl relay siting rigth above the radiator.

buy a mercedes

keep trying it will unlock it takes a couple times of unlocking it when the alarm goes off.

The recommended oil type for a 2004 Lexus GS 300 is 10 W 30. The oil capacity for the car is approximately 5.7 quarts.

a style of cars that started in japan. Very important person. Usually big rims on a luxury car and slammed to the ground.

The short answer is with parking sensors and electric power steering.The only thing you do is control the speed with the brake. There is a lot more to the system,But this is the basics.

The modern train runs on diesel fuel.

To remove the ignition cylinder on a 2000 Lexus RX300, first remove the vanity engine cover by unscrewing it. Disconnect the wiring connector by pushing the clip that holds it in place. Finally, remove the bolts that hold the ignition cylinder.

Just doing it on my '99 and it's a little painful. You need a 10mm socket, a Philips #2 screwdriver and small hands. Don't pry the light assembly off the bumper though, you'll break the plastic tabs and have to glue it back on.

For the front bumper, you take off the screws and bolts that hold the flexible panel under the car and inside the wheel well. You can then get your hand into the gap, grab the bulb holder, twist it and remove it from the housing.

For the rear bumper, you need to remove the mud-flap with an Allen key (hex wrench), screws that hold the flexible panel inside the wheel well and can then pry the bumper off enough to get your hand into the gap. Grab the bulb holder, twist it and remove it from the housing.

steps to set the remote control buttons on ES330:

1) close your garage door, set the opener in lock status,

2) push the button of a existed remote control for your garage opener,

at the same time push a selected button of the remote controller on your ES330,

keep pushing the both buttons for over 15 seconds until there is quick flash

happened in your ES330 car's remote controller,

3) push the leaning button in your garage opener once, then a leaning light will flash

on the opener,

4) then immediatelly push the selected button of the remote controller on your ES330

once, then push the button again, if the door did not open at this time, you should

push the button again.

5) now the you finished the setting on the remote button in your ES330.

In the transmission!

250hp @ the crank