0
Lexus
This category covers general questions on the Lexus company, a luxury division of the Toyota Motor Corporation. Lexus is most recognized for its quiet luxury cars unlike its main competitors Mercedes-Benz and BMW. For questions about specific Lexus models, please refer to the subcategories below.
1,633 Questions
Who made the recent Lexus car commercials?
The person who does the voice over in Lexus ads is James Remar. He played Richard Wright, one of Samantha's lovers in Sex and the City. He also plays Dexter's deceased dad on the Showtime series, Dexter.
How do you change the oil filter on a Lexus rx350?
Changing the oil filter on a Lexus RX350 is very easy to do .You simply take out the old insert and replace it with the new one.
How do you remove and install new quarter panel tail lights on a 1999 Lexus gs400?
Access the trunk, lights are held on by bolts and connected by a wire harness behind
the carpet.
Why will a Lexus rx300 only turn over when you press accelerator then immediately die?
Check for low fuel pressure.
How do you reset the time in the digital clock of a Lexus GX470?
Press "MODE" for 5 seconds, then when flashing, press "SET" till you get right time.
How do you reset the window jam protection on a 1998 Lexus LS400?
Turn on your Ignition. Open your window half way down (approximate) Press and hold the auto-up button until window closes. Continue holding the button for a few seconds and release. Confirm it works by testing the auto-up/down window button.
How do you get a stuck cassette out of your car cassette player on a Lexus sc300?
Take a golf tee and jam it in the one little opening of the tape. Use that to wiggle it out
Why does my 1996 Lexus ls400 smoke every time you turn it on?
I have a 93 with the same problem. It has 126k miles which should be nothing on a Lexus. I am going down the path of valve guide seals with mine. I'm pretty sure I'm right, but I will consult with a more experienced mechanic before I proceed with repairs.
What happens is that the oil sits in the valve train area after the vehicle is turned off. It then leaks past the bad seals into the combustion chambers when the is not running. When you start it, the excess oil combusts causing smoke. Once this oil is burned off, the car stops smoking. That's because the oil is circulating freely while the engine is running.
This will probably be an expensive repair at the dealership. I plan to fix mine myself.
What is the song on Lexus I350 commercial?
I have been personally searching this track myself for quite some time now, unfortunetaley though, this track does not exist. It was done exclusively for Lexus and the IS350 by Grayson Mathews Music and Soundfrom Toronto. It is based from Mozart Symphony No. 40 - Allegro Molto. However due tohigh demand, Grayson Mathews has decided todevelop a compilation CD that contains "Acceleration", the name of the advertisement for the Lexus IS350. They plan to have this out on iTunes by the end of the year.Until then, I guess we must wait patientlyand hold-out for the next couple of months. Added on June 16, 2007 The song is available on itunes. It is called Madame by Grayson Matthews.
Who is the announcer in the Lexus 'Moment' commercial?
The Lexus commercial announcer in the past commercials made movies. Is that correct?
The actress looks a lot like Tava Smiley, who was the host of TLC's "Clean Sweep" show. I'm trying to confirm that now. Let me know if you find anything! Thanks. It most definitely is Tava Smiley.
I would try limewire.com they have everything
your shotgun was made by high standard in the late 1970's to early 1980's. numerich gun parts has many parts for it available as they were able to buy most of high standard's inventory when the factor closed in 1984. you can find them at either www.e-gunparts.com or 1-845-679-2417. good luck
Why is it difficult to start your car when it is cold?
If the car cranks but will not start except in a cold only start situation (consistent), the condition could be caused by a failure in the fuel injection system, most FI equipped cars have a separate cold start circuit allowing the engine to start using the fuel supplied during this circuits operation which can last between 1.5 through 5 minuets depending upon make model and temperature both engine and ambient. This type of failure could be caused by the ECM (electronic control module) or a bad temp sensor, it could not be caused by a clogged fuel filter because this type of system generally shares the same supply system (i.e.: fuel pump, filters and lines.)
If the car cranks and starts cold and then after driving and stopping the engine will not crank (intermittent or constant) you may have a heat soak condition which will require the replacement of the starter / solenoid assembly. This is generally cause by armature windings and the magnets that surround the binding due to bearing ware and heat and is not caused by the solenoid.
Solenoid replacement tip - Most cars after 1970 except for the erroneous ford or Chrysler product do not have a separate solenoid - though in most cases the separate service of a solenoid is possible by the time you remove a starter that has the same or more run time as the solenoid why would you?
Generally a battery failure becomes more evident during a cold start so the likelihood of the condition being caused by a battery is slim.
More Information:
Check the solenoid and the starter. The battery charges itself through the alternator while you're driving. If the battery were the culprit you wouldn't be able to start the car no matter how long you waited until you had it jump started. If the radio, headlights, windshield wipers etc work but the engine doesn't even try to turn over (silence when you turn the key) it's probably the starter or solenoid. the solenoid uses low current from the ignition switch (keys) to complete a higher amperage circuit for the starter. If it isn't the starter or solenoid check for loose or burned wires from the battery to the starter, and check all fuses and fuesable links in the starting system. A good wiring diagram can be found in the proper chiltens repair manual for your vehicle.
Where can I sell my used Lexus?
There are many ways that you can sell a used Lexus. You can take an ad out in the local paper. You could also sell it back to the dealer. Antother way it to post it online with a with an online car dealership like Squiddo.
Who is the model in the Lexus commercial?
The model in the Lexus commercial is Dorotea Mercuri. Dorotea is an Italian/Greek actress and model. She has appeared in such magazines as â??Vogueâ??, where she also posed on the cover.
Who is CEO of Lexus North America?
Is Mark Emplin the current CEO of Lexus North America?
please excuse typos in Mark’s name.
Thank you
Phyllis Delatorre
916-671-4886
Why would a Lexus power window go up but come down about half way and wont stay up?
THAT MEANS THAT THE WINDOW IS NOT INITALIZED AND TO DO THAT YOU NEED HOLD THE WINDOW SWITCH ALL THE WAY UP AND HOLD IT THERE FOR A FEW SECONDS THEN PUT THE WINDOW DOWN AND HOLD THE SWITCH DOWN FOR A COUPLE SECONDS AND THEN IT SHOULD BE OK
Can you put regular gas in a Lexus RX330?
You can but you gonna have problems after 300k and performence wise you would feel like driving a toyota. If you put premimum theres less chances of repairs its a small difference
How do you replace the front turn signal bulb located on a 2000 Lexus 300?
I can speak for the Lexus '99 ES300. The instructions already provided for the '96 are very much on the mark. However, in the '99, there are only two 10mm bolts instead of three, and the turn signal assembly is fastened to the main headlighy assembly by a single phillips-head screw. After removing the splash guard, the two bolts, and the phillips-head screw, the turn signal can be CAREFULLY loosened and worked free from the fender, without fully removing the headlights. And unlike the '96, there is no clip to worry about, and no circuit board.
FOR 99' ES300 MODELS: You do not have to do the things mentioned above. The process is much easier and simpler. No need to even open the hood. All you have to do is pull the whole turn signal assembly forward. NOTE: It is important that you do NOT pull it sideways or even at an angle for it might break the plastic clip. There is only one clip holding the assembly from the frame. To start, use a screw driver or similar and insert it in the farthest part of the signal light assembly from the front. Pry gently to move the assembly forward about an inch or two to completely unlatch the plastic clip that is holding it in place. This clip is located in the middle of the assembly. Then remove the assembly still attached by the wires. Twist the lamp holder out of it's socket to replace the busted light.
Read more: How_do_you_remove_front_lamp_assembly_on_a_Lexus_ES300-98_to_replace_turn_signal_bulb
