0
Mercury Monterey
The Mercury Monterey was a full-size luxury vehicle produced by Ford Motor Company from 1950 to 1974. This front-engine, rear-wheel drive vehicle was offered as a four-door sedan or a two-door coupe.
161 Questions
Why did they stop making the Ford Freestar and Mercury Monterey Minivan?
The Ford Freestar was discontinued in 2009 along with the Mercury Monterey Minivan, being replaced with the Ford Flex.
Where is the engine control module - ECM - on a Ford Freestar or Mercury Monterey?
The ECM (Ford calls it the powertrain control module) is mounted to the firewall under the cowl panel on the passenger side.
To get to it first disconnect the battery ground cable then the plastic cowl panel must be removed along with the windshield wiper motor, the cabin air filter if equipped, and other things attached to the cowl panel. Remove the windshield wiper arms first and don't forget to disconnect the battery ground cable.
When you can see it, first loosen the bolt and remove the large electrical connector. Then remove the 2 retaining nuts and remove the PCM.
To install, reverse the removal steps. The mounting nut torque is 5 Nm and the electrical connector bolt torque is 7 Nm.
Be careful, the PCM is expensive.
Overhaulin' how can i get on the show?
lol you really probably can't. You probably have to live close I think its in california, and its just a matter of chance
How do you replace the spark plug wires on a 2004 Mercury Monterey?
Since the Monterey is the direct spin off of the 2003 Windstar, the information for the same question regarding the Windstar might be very applicable. (see below)
How do you retract the brake cylinder on the rear brakes for new pads on a 2004 Mercury Monterey?
The rear disc brake piston needs to turn as it is retracted / compressed into the caliper.
Go to the parts store and tell them you need the brake cylinder retraction tool. Cost about 10 bucks and works for a variety of cars/vans.
It is a square with a couple of different teeth on each face, to align with the notches in the face of the brake piston.
Should work with a 3/8 drive ratchet. Clockwise facing the cylinder to retract. Have fun!
What size engines did the 1963 mercury monterey have?
390 cubic inch V-8 with different carburator setups(250, 300, 330 HP)
How do you change the language on message center switch on a 2004 mercury monterey?
To change the language on the message center of a 2004 Mercury Monterey, turn on the vehicle and locate the "Menu" button on the message center controls. Press the "Menu" button until you see the language option displayed. Use the arrow buttons to navigate to your preferred language, then select it by pressing the "OK" or "Select" button. The message center should now display messages in the chosen language.
How do you change the heater core in a 1963 mercury monterey custom 390 cid?
To change the heater core in a 1963 Mercury Monterey Custom with a 390 CID engine, first disconnect the battery and drain the coolant. Remove the dashboard or access panel to reach the heater box, then disconnect the heater hoses from the core. Unfasten the heater core from the box, replace it with the new unit, and reassemble everything by reversing the steps. Finally, refill the coolant, reconnect the battery, and check for leaks.
Having trouble accessing panel to backdoor hatch 2004 mercury monterey mini van?
To access the backdoor hatch panel on a 2004 Mercury Monterey minivan, you'll need to first remove any screws or fasteners securing the panel. Look for screws hidden under plastic covers or in the handle area. Once the screws are removed, gently pry the panel away from the door frame, being cautious of any clips that may be holding it in place. If you're still having trouble, consulting a repair manual specific to your vehicle model may provide additional guidance.
How do you reset the drive cycle on the OBDII computer on a 2004 mercury monterey?
To reset the drive cycle on the OBDII computer of a 2004 Mercury Monterey, you can disconnect the vehicle's battery for about 10-15 minutes, which clears any stored trouble codes and memory. After reconnecting the battery, you will need to drive the vehicle through specific driving conditions to complete the drive cycle, including a mix of stop-and-go and highway driving. Make sure to follow the manufacturer's recommended drive cycle procedure to ensure all readiness monitors are reset.
Where is the O2 sensor located on a 2004 mercury monterey?
The O2 sensor on a 2004 Mercury Monterey is typically located in the exhaust system. There are usually two sensors: one upstream (pre-catalytic converter) and one downstream (post-catalytic converter). The upstream O2 sensor is usually found on the exhaust manifold or just after it, while the downstream sensor is located further back on the exhaust pipe, after the catalytic converter. For precise location, it's best to consult the vehicle's service manual or a repair guide.
