Remote Control Toys (RC)

Well you will need experience to do this. You need to get all the parts, wheels, motor, body, gears, ESC, steering servo, receiver and transmitter, and a few other things. They must all be able to fit together correctly, so same style parts (not always same brand).

You need to know how they all fit together, build the gear box and attach it to the base of your car. Put in the front steering mechanics, and wheels on all 4 Axel positions. Attach the motor to the gearbox. Put in the electrical systems and put on the body/cover.

Of course this is very basic because there are many small differences there could be in how you build it, there is even the possibility that you do some (not all) of them steps in a slightly different order.

Note: this was based on the construction of an electric RC car.

Most RC cars operate under a 2-channel radio system(steering and acceleration). The remote transmits a series of signals to two different servos on the car, the accelerator servo and the steering servo. these signals tell the car what to do

There is no horizontal rudder. The horizontal control surface is the elevator. The rudder steers, elevator makes the plane go up and down

It depends on what you want to do with your RC car or boat. If you want to increase your engine power you can get a Nitrous upgrade and make your boat or car go faster. If you want to make your car or boat there are body modifications you can do and you can even add lights to make your car or boat look awesome.

ya i want to no that to r they good i might get one

Most probably, you won't get it to run. Gasoline need a spark to ignite, R/c cars usually rely on another ignition system.

A sailplane has the same flight controls as an airplane. Ailerons to bank the wings, a rudder to keep the nose going straight through the air, an elevator to raise and lower the nose. Some sailplanes also have flaps on the wings to allow the sailplane to fly slowly.

Sailplanes have one flight control that only jets have. Spoilers are devices on the wings that the pilot can raise into the airstream to cause the wing to lose lift. Sailplanes are so aerodynamically efficient that they need spoilers to help the sailplane lose altitude for landing.

Sailplanes can stay in the air without an engine by utilizing rising air currents. Even though the sailplane is always sinking slowly, if the pilot can stay in pockets of air that are rising faster than the sailplane is sinking, the sailplane will climb and gain altitude. The pilot can then use that altitude to glide and search for more rising air.

By gliding forward from one source of rising air to another, a sailplane can cover great distances. Flights of over 300 miles are not uncommon and the world's record for distance is an unbelievable 1,362 miles.

The Soaring Society of America has a good website to use to get more information. www.ssa.org

The 1st commercially viable RC car was made in the 1940's, this was a nitro car. It was made by an Italian company called El-Gi (Elettronica Giocattoli).

The 1st electric car that was commercially available was made in the early 1970's.

a MICRO-T out of the box will go 15MpH very fast for the scale i have one i upgraded it and it will go 20 some will do 60 for 600$

Manufacturer, or model?

For model, you have the Escort (Ford), Elantra (Hyundai), Econoline (Ford), Explorer (Ford), Escalade (Cadillac), E-series (Mercedes Benz)...

For manufacturers, there is (or was)..

Eagle (USA), Enterra (Canada), Elfins (Australia), Evans (Australia), EMIS (Brazil), Edra (Brazil)...

If this is a plain trick question, consider this answer: electric car

I'm looking for a sow plow for a nitro buggy

There's no specific answer to that question. It depends on many factors including size of engine, size of fuel tank, nitro content of the fuel, weight of the vehicle, type of terrain you are driving on, driving style, etc.

It can be, but I would upgrade it with some tape and filling just in the plug to water proof it. If its a brushed motor do NOT run in in mud or water. That just ruins the brushes then it won't work. Nor Brushless don't run it in it rather, or have fun buying another VXL system.

well, some good RC CAR brands are yokomo. But I mainly know about offroad truck brands. The obvious choice would be traxxas, but there are lots of others like hpi racing, team losi and tamiya. Well all the brands I just listed make RC cars.

Yup. But you will need to make a hole in the rear part for the engine to poke thru.

Enable It to absorb more air and gasoline. In the the end it has to have proper fuel/air ration. Also bore kits make engine bigger internally. Better spark plug lighter internal parts etc. weight is a huge culprit other than detonation

if you mean gas as in petroleum they are just like a weed eater, prime them then pull the starter cord until they turn over. A nitro RC has many different ways, some use pull starts others have the traxxas easy start system or the hpi roto start and some use starter boxes that physically turn the engine.

The 1st commercially viable RC car was made in the 1940's, this was a nitro car. It was made by an Italian company called El-Gi (Elettronica Giocattoli).

The 1st electric car that was commercially available was made in the early 1970's.

There isn't really an "average price" unless you specify the size you are seeking. They make nitro rc engines for cars, they also make them for airplanes, so you would need to be more specific.

most likely "STEVENS" Model made by Henry Stevens in 2011 and its very good for pets and stuff

glad to help

Paper-mache is biodegradable, meaning that it will decompose and have no negative impacts on the environment. Other than that property, paper mache does not seem to be in any other way helpful to the environment, as it is aesthetically displeasing to look at, and is not a strong building material nor a reliable one, as it "melts" in water like cardboard.

I think is rear wheel drive car but stable in sliding

Good quallity RC cars have 5 main components. The motor(if you don't know what that does then that's sad), servo ( turns the wheels), Speed controller ( cotrolles the speed), reciver( gets all the commands from the controller and finally the transmitter( the controller). But of cousre if you bye some cheap thing , it will be the exact sam but with everything merged into one. oh and I forgot to say the bettery.

Ideally, working toilets (with paper) enough of which are gender neutral; sinks with running hot and cold water, hand soap, waste baskets, paper towels or other hand drying systems, materials and receptacles for hygienic needs of various kinds, ideally some equipment for ease of changing babies, cleanliness, appropriate privacy and spaceousness.