Saturn Vue

The valve cover torque specifications for a 2002 Saturn Vue typically range from 89 to 106 inch-pounds (10 to 12 Nm). It's important to follow a specific tightening sequence when applying the torque to ensure even pressure across the cover. Always refer to the vehicle's service manual for detailed instructions and specifications for your specific engine type.

To change the transmission filter on a 2003 Saturn Vue 2.2, first ensure the vehicle is safely lifted and supported. Drain the transmission fluid by removing the pan bolts, then carefully take off the transmission pan. Once the pan is removed, locate the filter, detach it from the transmission, and replace it with a new one. Reinstall the pan with a new gasket, refill the transmission with the appropriate fluid, and check for leaks.

To remove the instrument cluster from a 2002 Saturn Vue, first disconnect the negative battery cable to prevent electrical issues. Then, remove the trim panel surrounding the cluster by carefully prying it off. Unscrew the cluster mounting screws, and gently pull the cluster out. Finally, disconnect the wiring harnesses at the back of the cluster to fully remove it.

As of my last update, a Tango Ice Blast at Vue cinemas typically costs around £3.50 to £4.50, depending on the size and location. Prices may vary by cinema and promotions, so it’s best to check directly with Vue or their website for the most accurate and current pricing.

The manual transmission pressure switch on a 2003 Saturn Vue is typically located on the transmission itself, near the valve body. It can often be found on the side of the transmission case. To access it, you may need to remove the transmission pan or other components, depending on the specific configuration. Always consult the vehicle's service manual for precise location and removal instructions.

The transmission filter on a 2006 Saturn Vue is located inside the transmission, typically accessed by removing the transmission pan. To reach it, you'll need to drain the transmission fluid, remove the pan, and then take out the filter. It's advisable to consult the vehicle’s service manual for detailed instructions and safety precautions before attempting this task.

The body control module (BCM) of a 2002 Saturn Vue is typically located underneath the dashboard on the driver's side, near the fuse box. It is mounted to the metal structure of the vehicle, making it somewhat difficult to access without removing some interior panels. If you're planning to work on it, be sure to disconnect the battery first to avoid any electrical issues.

To remove the windshield washer tank on a 2004 Saturn Vue, first, ensure the vehicle is turned off and the battery is disconnected for safety. Then, locate the tank, usually positioned near the front of the vehicle, and remove any screws or bolts securing it in place. Disconnect the washer fluid lines and electrical connectors, if applicable, before carefully lifting the tank out of its mounting position. Finally, make sure to check for any remaining fluid before disposing of the tank.

Well, honey, the turn signal flasher unit on a 2004 Saturn Vue is usually located under the dashboard on the driver's side. You might have to do a little yoga to contort yourself into the right position to see it, but it's there. Just follow the click-click sound, and you'll find it in no time.

Oh, isn't that a happy little question! The fuse-relay for the electric Power Steering on a 2003 Saturn Vue is typically located in the fuse box under the hood of the car. It's like a little friend that helps the steering work smoothly. Just take your time, follow the wires, and you'll find it in no time. Just remember, there are no mistakes, only happy little accidents!

The coolant capacity for a 2004 Saturn Vue with a 2.2L engine is approximately 7.6 quarts. It is important to use the recommended coolant type and mix it with distilled water in the correct ratio for optimal performance. Overfilling or underfilling the coolant system can lead to overheating and potential engine damage.

No. No maufacturer's warranties cover tire wear. If you complain enough to your sales person, or to a Bridgestone/ Firestone retailer, you might get something???

Unfortunately the Dueler tires are junk, but that is what came on my vehicle. The car wasn't even out of warranty and the dealer was telling me to change the tires.

Well, when you've finished changing the coolant on your 2006 Saturn Vue and you notice the light is still on, don't worry, it just needs a little reset. Simply locate the fuse box under the hood, find the fuse labeled "ECM" or "ECU," remove it for about 30 seconds, then put it back in. This should reset the light and your Saturn Vue will be back to shining bright in no time.

Saturn Vue Has The 2 Front Seats And Also The Rear Seats Which Can Hold Up To 3 People By Law...

Engine light: (Often shaped like an engine or has the word "Check Engine") - Indicates a problem with the engine's emissions system.

Oil pressure light: (Often shaped like an oil can) - Indicates low oil pressure.

Brake warning light: (Often shaped like a oint) - Indicates a brake system circle with an exclamation pproblem.

Battery light: (Often shaped like a battery) - Indicates a problem with the charging system.

Temperature light: (Often shaped like a thermometer) - Indicates engine overheating.

The Saturn manual does not recommend conventional chains or cable due to tight clearances between the tire and front suspension. The Spider chains recommended by Saturn are over priced at $400 Plus. So I took some measurements and the clearances are tight. I purchase some $40 Cobra Cable chains made by Quality Chain, Hillsboro, OR for 235/60/17 tires that came with the Vue. Auto Zone selected the cables on the computer and recommended a set of cable tightners for $5. I installed the cables and tightners and check the clearances. The cable to Strut has 1" clear and the top of tire to underside of the strut spring support plate is only 1/2". So I drove it on dry asphault up to 20 MPH and had no noise. I believe cables will work well, if you keep your speed down and decrease it if you hear any metal to metal noise.

For a 2006 Saturn Vue 6 cylinder, it is recommended to use 5W-30 viscosity oil. This oil helps to ensure proper lubrication and protection for the engine in varying temperatures. Be sure to consult your owner's manual for the most accurate information.

I don't know about the 3.5L, but on the 2003 Saturn Vue 2.4L and the 3.0L, it's in the fuel filter. You can get the fuel filter for the 2.4L at any auto parts house, around $70.00. The 3.0L fuel filter/regulator, is a dealer item.

I'm working on a car with the same problem. From what I've read, this is a common problem amongst the VUE's c.2002 - In fact, there is a Technical Service Bulletin about this very problem which indicates that it is a problem with the Throttle Body and/or Throttle Position Sensor and relevant wiring harness. You should be able to find this T.S.B. online somewhere for free or just call your local dealer. As a side note, the 2002 VUE has about 192 T.S.B.s currently which is a bit above normal for a car of this age. Hope it helps! Cheers, Z. Harris ASE Certified Automotive Repair Technician unclezach1@yahoo.com

You should go to a Saturn dealership. They will cut the keys on site and program the chip with your VIN #. Replacement keys cut at a hardware store, Walmart, etc. won't work due to the chip located in the original key. I just got 2 made and they (the dealership) charged $7.50 per key. Go any place that cuts keys, hardware store,walmart,auto parts store. They will use the keys you have to cut new one .

On a 2003 Saturn Vue with a 2.2-liter engine, the Positive Crankcase Ventilation (PCV) valve is located on the valve cover. It is typically found near the back of the engine, connected to a rubber hose that leads to the intake manifold. To access it, you may need to remove some components for better visibility.

How many quarts of oil does a Saturn sl1wagon 1.8 dual overhead camtake

The thermostat is located below the intake plenum assembly, on the passenger side. I believe you can see a part of the thermo from the pass side. It is a labor intensive process to replace it, hence the ~$300 repair quote from dealership. A lot of engine components have to come off to get to the thermo. The trickiest part of the replacement is finding the tool to undo the hose clips that hold the rubber on the plenum. These clips are called clic-R collar hose clamps. I've found a few vendors on eBay who sell the tool, but can't find it in/on any tool website. This guys eBay store seels the tool. http://stores.ebay.com/KONIKTOOLS CLIC-R COLLAR PLIERS 1212