Volume

That completely depends on what the "4 and 1 half" are, and there are not
necessarily any answers at all for some of the possibilities. For example, there
are no quarts at all in 41/2 months, kilograms, pages, miles, volts, or megahertz..

1 meter cube = 1000 liters

1 liter = 1000 milliliter

1 meter cube = 1 000 000 millilter = 1 million mL

224 tbsp

1 cup = 16 tbsp

1 tbsp = 0.06 cup

224 tbsp

just got the same prescription today i called the pharmacy and the pharmacist said 5 mls is one (1) teaspoon. hope this helps

The number of barrels needed to fill up a pool depends on the size of the pool. On average, a barrel of oil holds about 42 gallons of oil. You would need to calculate the volume of your pool in gallons and then convert that into barrels to estimate how many barrels you would need to fill it.

If the US ounce (for foods labelling) has 30 mL the answer is 1 800 m l.

1/2 pint = 0.0625 US gallons

You can't without more information, a kg is a unit of weight or mass and a cubic meter is a measure of volume.

You can work out what a cubic meter of SOMETHING will weigh in kgs - but you need to know what that SOMETHING is (you need to know its density).

The number of unit squares that fit inside a surface describes its area. Area is a measurement of the size of a surface, quantifying the amount of space it covers in two dimensions.

there are 480 milliliters per pint (473 USP) one pint equals 480ml. 30ml per oz times the number of ozs

Foot Sample

When chemical carriers load high value and very pure products, they will commence loading until about one foot of cargo is in the bottom of the tank, then stop. They will take a sample this cargo, known as the foot sample up the facility's lab for analysis to see if during the loading of this one foot of cargo there was any contamination. If not, they will resume loading the tank until completion. If contamination is present in the foot sample they will try to determine the source, while they pump the now off spec cargo to the shore, and start over again, It is hoped that the amount loaded during the foot of cargo is enough to clean the contamination from the tank and piping. This is done to prevent the entire tank being loaded and then contaminated thereby requiring the full cargo to be reprocessed.

A gallon of gasoline weighs approximately six and one half pounds. This is using a specific gravity of .77 although lighter specific gravity could be used, between .71 to .77.

There are 30 "ml's" ( millileters) in an ounce so, 192 ounces would be 5760 "ml's"

1 L is just over 1/4 US gallon (0.264 US gallons).

9 US cups = 2.13 liters

Undefined. Gallons are volume. Tons are weight. Weight and volume are not convertable.

==========

APPROXIMATE ANSWER:

240 US liquid gallons of water per short ton.

276 US liquid gallons fuel (diesel) oil per short ton.

1 short ton is 2000 pounds.

8.35 pounds is one US liquid gallon of water.

86.7% is the density of fuel oil relative to water.

750 ml = 25.36 US fluid ounces or 26.40 British fluid ounces

(1)how many milliliters are in a pint and (2)how many milliliters are in a pint are different becausenumber 2 is spelled right and number 1 is spelled wrong it is

m-i-l-l-i-l-i-t-e-r-s

milliliters

28.34 ml in an ounce.

To convert liters to milliliters, you need to multiply the number of liters by 1000 because there are 1000 milliliters in 1 liter. This means that if you have, for example, 2 liters, it would be equal to 2000 milliliters.

The volume of a cylinder is given by the formula V = πr^2h, where r is the radius and h is the height. Given a diameter of 155 mm, the radius is 77.5 mm. Converting to inches, this is approximately 3.05 inches. Plugging these values into the volume formula, the volume is approximately 757.20 cubic inches, which is equivalent to about 3.28 gallons.

35 ppm means 35 parts per million, whereas percentage means parts per 100. The simplest way to get the answer is to say 35 parts per million, that's 0.035 parts per thousand (move decimal point three places to left), so 0.0035 parts per hundred (move decimal point another place to left)

No 128. 1 gallon makes 128 ounces and 1 ounce is 0.0078 gallon in U.S measure. There are 8 ounces in a cup, 2 cups in a pint, 2 pints in a quart and 4 quarts in a gallon. That makes 128 ounces in a gallon US. In UK 20 ounces to the pint, 8 pints to the gallon which makes 160 ounces Imrerial measure.

Mobil DTE 25 has a specific gravity of 0.876. Water weighs 62.387531 pounds per cubic foot. Therefore, one cubic foot of Mobil DTE 25 weighs 54.651477 pounds. Most hydraulic fluids have a similar specific gravity.